选矿厂

  • 网络concentrator;mill;concentration plant;Mineral processing plant
选矿厂选矿厂
  1. 拉萨河流域选矿厂分布及其对环境的影响

    Study on the impact of mineral processing plant on environment in Lhasa river catchments

  2. 拉么锌矿选矿厂通过将锌精选尾矿返回扫选、药剂制度的调整等工艺技术改造,较好地解决了长期以来铜和锌回收率低的问题。

    Lamo Mineral Processing Plant county solved the problem of the low recovery rate in reclaiming zinc and copper , with the technology improvement of tail of concentrating in to scavenging and the adjustment of the medicament system .

  3. 选矿厂设计CAD设备图形库管理系统

    Equipment graph base management system for CAD of ore dressing plant

  4. PLC智能型程控加药机在选矿厂的应用

    Applied PLC Intelligent Programmable Dosing Machine to Ore Dressing Plant

  5. 选矿厂磨矿分级模糊自调整PID控制工程研究

    The Study of Grinding-Classification Based on Fuzzy PID in Selected Ore Factory

  6. 铜矿选矿厂矿浆pH值检测中电极的选择

    Selection of Electrodes for determination of pulp pH Value of Copper Ore Dressing Plant

  7. CAD技术在选矿厂设计中的应用

    Application of CAD techniques in concentrator design

  8. 在POWERBUILDER环境下实现选矿厂微机核子秤系统的设计开发

    The Microcomputer Nuclear Weigh System of Concentration Plant Designing and Developing in the Power Builder Condition

  9. HP圆锥破碎机在选矿厂改造中的应用

    Application of HP-type Cone Crusher in Reformation of Concentrator

  10. DCS系统在选矿厂的应用

    Application of DCS System in Ore Dressing Plant

  11. DEA方法在选矿厂生产力利用率分析中的应用

    DEA Method in the Analysis of Productivity Utilization in Mineral Processing Plant

  12. VB在选矿厂设计计算及设备选型中的应用

    Application of VB in calculation of concentrator design and selection of mineral processing equipment

  13. S7-200系列PLC在选矿厂小流量控制系统中的应用

    Application of PLC of ST-2000 Series to Small Flow Control System for Concentration Plant

  14. MCGS在选矿厂磨矿分级自动化中的应用

    Application of the software MCGS in ore grinding and classification in dressing plant

  15. 介绍了核子称等仪表在选矿厂的自动化计量实施方案,并通过PLC、网络总线和工控机对计量结果进行统计。

    This paper introduces the applied automatic measure of nuclear weigh instrument in the ore process factory and adds up the results by PLC , network and computer .

  16. 根据选矿厂碎矿生产工艺的控制要求,采用PLC和工控组态软件设计开发了一套计算机监控系统。

    In light of the requirement for the crushing process control of concentrators , a computer control system was developed by using PLC and industrial control configuration software .

  17. 选矿厂WG型给药机控制系统的改进

    The Improvement of Control System of WG Reagent Feeder in the Concentrator

  18. S7系统在选矿厂破碎车间改造中的应用

    S7 Control System Application on the Improvement for the Crushing Shop of Ore Dressing Plant

  19. 采用PLC控制和计算机监控技术,选矿厂的破碎生产过程实现了设备自动启停和细碎机负荷的自动控制。

    The automatic start and stop of equipment and the automatic control of the load of fine crusher in the crushing process of the concentrator were realized by applying PLC control and computer monitoring technology .

  20. 酒钢选矿厂原料F2皮带尾部除尘系统设计

    Design of the Dust Removing System at the Tail of F2 Belt for Raw Material at Jiuquan Steel ( Group ) Co. 's Concentrator

  21. 介绍了HP型圆锥破碎机在包钢选矿厂、武钢程潮铁矿选矿厂和辽宁阜新排山楼金矿选矿厂碎矿改造中的应用情况。

    The application of HP cone crushers in Bao Steels concentrator , Chengchao Iron Concentrator , Wu Steel and the transformation of crushing in Fuxin Paishanlou Cold Concentrator , Liaoning is described .

  22. 针对选矿厂原料F2尾部粉矿皮带在转载运输过程中产生大量的粉尘,污染车间工作环境。

    Great amount of dust was produced during the load transfer at the tail of F2 powder ore belt of the concentrator and polluted the work environment .

  23. 讨论了选矿厂工艺设备配置图设计中CAD技术应用的三种主要方法,结果表明,参数化绘图是最有效的途径之一。

    Three basic methods for application of CAD techniques in the engineering plotting of process equipment flowsheet arrangement in concentrator were discussed . As a result , it is shown that the parametrization plotting is one of the most effective ways .

  24. 结合工程实例,采用DH+网络技术、PLC控制技术及工业自动化组态软件技术实现了选矿厂自动监控和管理系统。

    Combined with engineering example , an automatic monitoring control and management system in mineral processing plant is introduced . In the system , DH + network technology , PLC control technology and industry automation configuration software technology were adopted .

  25. 介绍了美国德瑞克DERRICK重叠式高频细筛在莱芜铁矿选矿厂第一阶段扩能改造中的应用和效果。

    The application and its results of US Derrick overlapping high frequency fine screen in phase 1 capacity expansion and transformation of Laiwu Iron Mine 's concentrator are described .

  26. 小型关系数据库管理系统TDMS选矿厂水质处理

    A Miniature Relation Database Management System TDMS Control and Treatment of Concentrator 's Water Quality

  27. 根据MIS系统两种开发模式的特点,针对用户需求,采用了B/S和C/S混合模式,开发了选矿厂管理信息系统。

    According to the characteristics of two development modes in MIS and the requirement from users , a mode mixed by C / S and B / S is used to develop an information management system of concentrating mill .

  28. 利用矿山日处理150t原矿的选矿厂,以小型试验研究为依据,进行了浮选分离汞锑中降铬工艺的工业试验研究。

    Based on the results of laboratory test , commercial tests of Hg-Sb flotation separation were performed in a 150t / d plant .

  29. (用喷水空气泵抽空的装置)湿体系抽空选矿厂渣浆泵存在问题分析及ZJ渣浆泵的应用

    Wet system of evacuating Analysis on the Problems of the Slurry Pump in the Ore - dressing Plant and Application of ZJ Slurry Pump

  30. 介绍了洛阳栾川钼业公司3000t/d选矿厂设计过程中遇到的问题,提出了解决的办法。

    The questions in the 3 000 t / d concentrator design processing was included and the solution was put forward .