测量深度
- 网络measured depth;Measuring Depth;Measure Depth
-
最大测量深度200m,最大连续工作时间3h。
Maximum measured depth underwater is 200m , and maximum continuous working time is 3 hours .
-
结论照射野大小和测量深度对楔形因子Fw均有影响:其中照射野的影响不大,可忽略;
Conclusion We believe the field size and may affect on the Fw , but the influence from field is small and can be neglect ;
-
深度游标卡尺用于测量深度,台阶等。
The depth vernier gauges can be used to measure depth and step .
-
但测量深度的影响却很大,不能忽略。
Yut the influence from depth cannot be neglect .
-
环芯法测量深度方向上的残余应力分布
The measurement of the distribution of residual stresses on depth by ring core method
-
船舶转向对测量深度的影响
The Effect of Vessel Turning on Surveying Depth
-
剂量计算公式总散射校正因子测量深度的研究
Measurement with total scatter calibrate factor at different depths in the calculation of prescription dose
-
关于水运工程水深测量深度误差限值的探讨
Investigation on the Error Limit of Depth through Bathymetric Survey in Port and Waterway Engineering Project
-
测量深度的航海单位。
A nautical unit of depth .
-
初步尝试利用观察比较法确定光纤测量深度,保证每次光纤浸入深度相同。
Observation-comparison method is adopted to ensure the deepness of fiber in the sample to be identical .
-
测量深度控制轮底部与安装设备放置平面的距离就为大致的埋设深度。
Measure the spacing between the bottom of depth wheels and the surface ? the result is approximately the embedding depth .
-
采用的静态精度评估方法就是在多波束测深系统静止的条件下考核其对同一位置测量深度的误差;
The static precision evaluation method is to measure the error at the same depth under the static condition of the system ;
-
测量深度的航海单位。(以测深杆)测定船舱内的水深。
A nautical unit of depth . find the depth of water in a ship 's hold ( with a sounding rod )
-
目的研究楔形因子与照射野大小和测量深度的相关性,为临床准确使用该因子提供依据。
Objective To study the relation between the field size and depth of Fw ( wedge factor ) and its effect on the clinical usage .
-
该方法适用于地形较复杂,松散覆盖层分布广泛的地区,具有测量深度大、方法简便、技术成熟、经济等特点。
It is suitable for the area with complicated terrain and large loosening layer and with the characteristics as wide surveying depth , easy to use , mature technology and economy .
-
其特点是在井中一系列测点上测量不同深度的重力值。
It measures gravity values at different depth points in borehole .
-
钢管接箍测量及深度定位
Measurement of Steel Tube 's Joining Hoops and Its Depth
-
非接触模式下测量前房深度的生物学方法评估
Evaluation of biometric methods for measuring the anterior chamber depth in the non-contact mode
-
利用高音频电流测量裂纹深度及裂纹扩展
Determining the Crack Depth and Fatigue Crack Growth by Means of High Acoustic Frequency Current
-
测量海洋深度的方法。
Measuring the depths of the oceans .
-
眼前节图像分析系统与A超测量前房深度及晶状体厚度的比较
Comparision between anterior eye segment analysis system and A ultrasound in anterior chamber depth and lens thickness
-
输入门框的深度。垂直墙面测量门框深度。那盆花蔫儿了,叶子都倒垂了下来。
Enter the depth of the door frame . The door frame depth is measured perpendicular to the face of the wall .
-
与任何新测量的深度相反的图中暗礁的深度在即将到来的庭审中可能会出现。
The depth of the reef on the charts as opposed to any newly calculated depth may emerge during forthcoming court hearings .
-
为此提出了一个既能避开峰值时间又能被红外热像仪探测和记录的新参数,从而达到测量缺陷深度的目的。
So a new parameter was put forward for determining defect depth which could avoid peak time and be recorded by thermographic instrument .
-
通过实验将实际测量的深度信息和恢复的深度信息对比,验证了计算深度信息的可靠性。
With the comparison of the recovery depth info and the measuring depth info , the experiment shows that the recovery method is reliable .
-
他们把热敏感卫星和许多直接测量不同深度的海水温度的漂浮物结合起来。
They use a combination of heat sensitive satellites and thousands of floats that directly measure the temperature of ocean water at various depths .
-
通过模型试验测量大深度载人潜水器低速大漂角运动时所受到的非线性水动力。
The nonlinear hydrodynamic forces on a deep manned submersible at a low forward speed and large drift angles are determined by a model test .
-
这一特定群体的老年人在90年代收入增长缓慢,有可能陷入以收入口径测量的深度贫困。
The article found that income for the target group increased slowly during 1990s and they could suffer a deep poverty gap with household income measurement .
-
通过调整此体模片的叠放顺序可以测量不同深度处的吸收剂量,使用方便,易于操作,且重复性好。
We can measure the dose at different depth by changing arrange of this phantom , as it is easily used and less complicated to operate and has a good repeatability .
-
通过分析磁矫顽力与渗碳层深度之间的关系,应用所试制的电磁无损检测仪(DWY-1)测量渗碳层深度。
The relationship between the depth of carburized layer and magnetic coercive force was studied . Based on this relationship we measured the depth of carburized layer by electromagnetic nondestructive measurement instrument ( DWY-1 ) .