机车牵引

  • 网络locomotive traction
机车牵引机车牵引
  1. 6K机车牵引座载荷分布特征及其结构延寿的研究

    A Study on Load Distribution Feature and Structure Life Prolongation of 6K Locomotive Traction Seats

  2. 主要介绍了TD机车牵引齿轮脂在韶山&Ⅰ型机车上的使用情况,行车试验表明:TD机车牵引齿轮脂能满足机车牵引齿轮对润滑的要求。

    Application of TD locomotive traction gear grease in Shaoshan - 1 locomotive is introduced . The result shows the grease can satisfy the lubricating requirement of locomotive traction gear .

  3. PLC在电力机车牵引变电所控制中的应用

    Application of PLC in control of transformer substation for electric locomotive

  4. 基于DSP的电力机车牵引试验台控制系统设计

    Design of Control System for Traction Test Rig of Electric Locomotive Based on DSP

  5. ND5型机车牵引电动机转速传感器故障探讨

    A study of failures of speed sensors of ND_5 locomotive traction motors

  6. F型机车牵引梁铸造过程数值模拟及工艺优化

    Numerical Simulation and Technique Optimization of the Casting Process of the F Type Draft Sill

  7. SS7型电力机车牵引齿轮系统的有限元三维接触分析

    A finite element 3D contact analysis on tractive gear system for SS_7 electric locomotive

  8. EL型矿山电力机车牵引电动机断轴及小齿轮磨耗过限

    EL of Mine Electric Locomotive Traction Motor Shaft Breakage and Pinion Wear off Limits

  9. SS9型机车牵引通风系统设计分析与试验调试

    Design Analysis and Experiment Debug of the Traction Ventilation System on Type SS_9 Electric Locomotive

  10. 东风(4D)型机车牵引齿轮箱的改进设计

    Improvement design of traction gearbox for DF_ ( 4D ) locomotive

  11. TD机车牵引齿轮润滑脂

    Traction Gear Grease TD for Locomotive TD for Locomotive

  12. HXD1型机车牵引装置上的螺栓连接

    Bolt connection of traction device on type HX_D1 locomotive

  13. DF4型机车牵引齿轮罩甩油窜油原因浅析

    Analysis of the oil slinging and carrying over of the tractive driving gear cover of DF_4 diesel locomotive

  14. SS7型电力机车牵引杆座可靠性分析与改进设计

    Reliability Analysis and Improvement Design of Traction Link Seat for SS7 Electric Locomotive

  15. 机车牵引齿轮静动态分析及在东风4D客运机车中的应用

    Static and Dynamic Analysis of Locomotive Driven Gear and Its Application in DF - 4 D Locomotive

  16. 减少东风(4B)型机车牵引齿轮罩裂损的几点作法和建议

    Some measures and suggestions for reducing traction gear cover cracks of DF_ ( 4B ) locomotives

  17. 内燃调车机车牵引电动机改进方案探讨GK(2C)型液力传动调车内燃机车

    Discussion on improving the traction motors for shunting diesel locomotive GK_ ( 2C ) diesel - hydraulic shunting locomotive

  18. DF(4B)型机车牵引电动机磁场削弱电阻烧损的原因分析和防止措施

    Analysis and preventing method for burn through of traction motor 's magnetic field diverter resistor of DF_ ( 4B ) locomotive

  19. DF(4A、4B)型机车牵引整流柜烧损故障浅析及预防措施

    A preliminary analysis and preventive measures of burning of DF_ ( 4A ) and DF_ ( 4B ) locomotive traction rectification cabinets

  20. 东风(4C)型机车牵引齿轮罩甩脂窜脂的原因分析及解决措施

    Reason analysis and countermeasures of grease sling and blowby of the tractive driving gear cover for DF_ ( 4C ) locomotive

  21. 8G型电力机车牵引电机轴承故障的振动诊断

    Vibrating Diagnosis of the Faults of Traction Motor Bearings of 8G - Type Electric Locomotive

  22. 本文导出了两种特殊接法的电力机车牵引变压器,即V/V接法的变压器和斯夸特(Scott)变压器的三相模型。

    The three-phase models of two kinds of traction transformers of nonconventional connection structures , i. e. , V / V transformers and Scott transformers , are derived in this paper .

  23. 东风(4B)型货比客运机车牵引电动机落修高的原因分析

    An analysis of the reasons for a higher overhaul rate of traction motors for DF_ ( 4B ) passenger locomotives with a freight gear ratio

  24. ZD105脉流牵引电动机是装配韶山4型(SS4)电力机车牵引电动机。

    ZD105 pulse-current traction motor is mounted in SS4 electric locomotive .

  25. 最后以DJ1型电力机车牵引电机的故障诊断为背景,开发研制了机车牵引电机故障诊断系统。

    In the end , " Fault diagnosis system of traction motor on electric locomotive " based on the research of DJ_1 electric locomotive was designed and implemented .

  26. O′ZBEKISTON型机车牵引风机柜振动及开裂问题处理方法探讨

    Discussion on solution for the vibration and crack problems of traction motor blower cubicle on type O ′ ZBEKISTON locomotive

  27. 大功率4H-SiCBJT是非常具有竞争力的器件种类,可以广泛应用于诸如航空航天、机车牵引、高压直流输电设备、混合动力车辆等国计民生的重要领域。

    High power 4H-SiC BJT is very competitive in power device family , which is widely applied in both military and civilian use such as aerospace , traction , HVDC facility , HEV .

  28. 介绍了SS7型电力机车牵引杆座的裂纹情况,应用有限元法分析了裂纹发生的原因,指出在牵引杆座前后加设加强筋板使结构的局部区域刚度失调是造成裂纹的主要原因。

    Cracks in the traction link base of SS7 electric locomotive are shown and reasons are analyzed with finite element method . The main reason is pointed out that reinforced sheets are used before and after the traction link base , leading to uneven partial rigidity .

  29. 分析HXD1型机车牵引座的螺栓连接方式中的特殊点及其机理,并通过受力计算说明了衬套对螺栓使用可靠性的影响。

    This paper analyses the special points and mechanism of bolt connection mode on type HXD1 locomotive traction base , and shows the effect of bush to bolt application reliability by stress calculation .

  30. 分析了电力机车牵引系统动力学模型及其粘着控制问题,利用基于多分辨率分析的模糊系统(MAFS)方法,根据系统输入和输出数据,建立具有优化结构的电力机车粘着控制对象的模糊系统模型。

    Dynamics model of electric locomotive traction system and its adhesion control were analyzed . Based on the system input-output data , fuzzy system model of the electric locomotive adhesion control with optimized structure was constructed by multi-resolution analysis based fuzzy system ( MAFS ) method .