负载能力

  • 网络load capacity;carrying capacity
负载能力负载能力
  1. 在功放部分,采用了输入输出滤波电路及电源耦合电路,使带负载能力大为提高,在接上4欧负载时输出波形稳定无失真。

    Input and output wave filtering circuits and power-source coupling circuits are applied in power release , which make capacity abilities more power and output waves are steady authentic when connected to 4-ohm capacity .

  2. TTL门电路带负载能力的计算问题研讨

    Calculation of the load capacity in TTL circuit

  3. 大量并发的Web服务请求的存在,对Web服务的负载能力及其服务性能提出了极大的挑战。

    Too many concurrent requests pose a big challenge for the load capability and performance of Web Service .

  4. 证明实验中设计的独立双池SBS相位共轭镜结构具有较高的负载能力,是高效的。

    The independent two-cell SBS phase-conjugation mirror has much higher load capability and is higher efficient .

  5. 在此基础上从传输速率等方面理论论证了软件SPI口对相应芯片的负载能力。

    The loadability of the software serial peripheral interface is on data transmission rate .

  6. 该电路不仅结构简单,无源灵敏度低,而且直接从z端输出,因而具有带负载能力强的特点。

    The proposed circuits have not only simple structure , low passive sensitivity , but also strong driving ability through z terminate .

  7. 主要表现为:对边缘服务器存储负载能力以及P2P节点文件请求响应时间的要求。

    Main show is the requirement to load capacity of surrogate server storage and the limitation of time expending for the response of file request by the peer .

  8. 此外,本文设计了一套与NI运动控制卡协同工作的步进电机驱动器,增强运动控制卡脉冲信号的带负载能力,驱动芯片台工作。

    In addition , a stepper motor driver was designed for drive chip carrier , which could enhance the load capacity of the pulse generated by NI motion control card .

  9. RAINBOW压电驱动器是一种具有超大位移量和一定负载能力的新型压电驱动器。

    RAINBOW ( Reduced And Internally Biased Oxide Wafer ) actuator is a type of actuator with characteristics of ultrahigh displacement and moderate load capacity .

  10. 随着片上系统数字处理单元的集成度不断提高,如将DSP,ARM整合到同一个芯片内,其对电源系统的带负载能力和效率的要求越来越高。

    With the system on chip integration of digital processing unit increasing , such as the DSP , ARM into a single chip , there are higher requirement on load capacity and efficiency of power supply unit .

  11. 指出在适当的抽运条件下,固体介质的SBS负载能力可以高于材料自身固有的光学损伤阈值,并具备实现高相位共轭保真度的潜力。

    In suitable pumping conditions , the load ability can be above the optical damage threshold of the solid media , and there 're potentials to achieve high phase-conjugate fidelity .

  12. PWR折衷了串联机器人与并联连杆机器人的优缺点,具有较高的刚度、精度和负载能力,结构紧凑,但是其工作空间较小。

    This kind of mechanism has advantages of comparatively higher stiffness , precision , load capability and compact structure but the disadvantage of comparatively smaller workspace .

  13. DDC算法基于簇的局部信息对节点在下一轮中的能量水平及其负载能力进行预评估,并给出了相应的预评估因子。

    In DDC , the pre-evaluation factors which are used for pre-evaluating the energy level and load ability for each node in the next round are presented .

  14. 它可以解决现有UPS工作效率低,稳定性差,负载能力有限等问题。

    It can solve the existing UPS low efficiency , poor stability , load ability is limited , etc. Through the application of the embedded technology also greatly improved human-computer interaction of UPS and communication ability .

  15. 而诸如远程教育、视频会议、IPTV、网络游戏等宽带应用都对当前网络的负载能力提出了挑战,使得组播成为了一种必要通信方式。

    Broadband data applications , such as distance learning , video conferencing , IPTV , online games , pose a challenge on the carrying capacity of the current networks , multicast communication becomes necessary .

  16. 输出点的同时工作系数为0.5,单个输出点的负载能力可达0.5A。

    Simultaneity factor of outputs is0.5.Output current for each output is0.5A .

  17. 高分子聚合物基质高效液相色谱固定相具有选择性高、使用pH范围宽、亲水性好、稳定性好以及负载能力高等优点,更适合于生物工程产品的分离纯化和制备,是固定相的发展趋势。

    Polymeric separation media having a of high selectivity , chemical stability in the entire pH range , good hydrophilicity , high column loading , are more suitable for biopolymer separation , and will be the tendency for the development of stationary phase in the future .

  18. 同时,基于对话框的MFC应用程序开发,简化了人机交互界面的设计。本文对系统资源的实时监控与负载能力的分析做出了深入研究。

    At the same time , depending on the MFC dialog application model , the design of UI user interface is simpler . I have made a deep research of system resource monitor and load capacity analysis .

  19. 通过对比测试表明,LPT-2000具有较高的包捕获能力和产生负载能力。

    Numbers of test results prove that LPT-2000 has high performance in packet capture and traffic injection .

  20. 在今年九月份的官方发布会上,为了展示这些桥梁的负载能力,军方特别拍摄了一组70吨重的M1A1主站坦克开过桥的照片。

    To demonstrate its strength a70-ton M1A1 Abrams tank was driven across the bridge at its official unveiling in September .

  21. 固体氧化物燃料电池(SOFC)作为分布式电源,具有结构简单、低噪声、负载能力强、污染小、综合利用效率高和寿命长等优点,越来越受到人们的关注。

    SOFC has the advantages of simple structure , low noise , high load capacity , less pollution , long life and high comprehensive utilization efficient , etc , so SOFC has been played more and more attention as distributed power .

  22. 据Axion表示,这两座分别长40英尺和80英尺的桥梁其负载能力可达130吨,其用途是供作战车辆通行。

    Both the40-foot and80-foot bridges to be built will each have a high-loading rating of130 tons , and be used to transport both locomotives and freight traffic , according to Axion .

  23. 为了恢复8m×6m风洞动力系统的负载能力,提高其稳定性与可靠性。

    In order to resume the load ability of power system in 8m × 6m wind tunnel , improve its stability and reliability , the original analog speed regulated system of 8m × 6m wind tunnel has been successfully reformed recently .

  24. 为保证认证服务系统安全、高效、稳定地工作,采用了IOCP技术和内存池技术来增强系统的并发处理能力和负载能力。

    In order to ensure that the system works securely , efficiently and stably , the techniques of IOCP and memory pool are employed to enhance its capacity of dealing with concurrent connects and ability of load .

  25. 所研制的微动机构重量1kg、精度高于0.04mm,负载能力大于3kg,满足宏-微机器人系统精密作业要求。

    The micro mechanism is compact , weighting only 1 kg with a load capacity more than 3 kg and a precision higher than 0.04 mm , meeting the demand of high-precision manufacturing .

  26. 水润滑艉轴承负载能力的分析

    Analyses of the load capacity of water lubricated stern tube bearing

  27. 关于干式电力变压器负载能力的讨论

    Discussion on the Load Capacity of Dry-Type Electric Power Transformers

  28. 机器人动态负载能力及结构参数的优化

    Dynamic load capacity and stuctural parameters optimization of Robotic Manipulators

  29. 该系统机车效率高,带负载能力显著增强。

    The efficiency of mining locomotive was improved as well as loaded performance .

  30. 是影响连接部分断裂负载能力的最主要因素。

    Depth of Solder Penetration drastically affects the breaking load of the joint .