硅铬合金

硅铬合金同时降低碳、磷的探索

Discussion on simultaneously reduce carbon and phosphorus contents in SiCr alloy

高碳铬铁与硅铬合金的转炼实践

Transition smelting practice between HIGH CARBON FeCr and SiCr

ICP-AES测定硅铬合金中铝和锰

Determination of aluminium and manganese in chromium-silicon alloy by ICP-AES

试验表明，采用还原脱磷法使硅铬合金同进降低C、P是可行的。试验取得了脱磷率90.9%、脱碳率75.7%的较好结果。

The test shows that it is feasible to reduce carbon and phosphorus contents simultaneously by reducing dephosphorization , and the test has achieved good results of dephosphorizing ratio 90 . 9 % , decarbonizing ratio 75 . 7 % .

波伦法液态硅铬合金热兑生产实践探讨

Probe into practice for hot silicochromium charging in Perrin Process

硅铬合金摇包脱碳最佳工艺条件的研究

Study on optimal decarburization condition of silicochromium in shaking ladle

固态硅铬合金热兑法生产微碳铬铁的实践

Practice of producing extra low carbon ferrochromium with solid SiCr by Perrin Process

本文简述了硅铬合金摇包脱碳的基本原理。

The basic principle of carburization of silicochromium alloy in shaking ladle is simply described .

特种硅铬合金冶炼工艺浅析

Briefly analysis of special SiCr smelting process

浅论硅铬合金降碳

Simple introduction of decreasing carbon in silicochromium

硅铬合金渣洗脱碳

Wash heat decarbonization of SiCr alloy

硅铬合金碳偏析试验

Carbon segregative tests on silicochromium

介绍了硅铬合金生产中造成炉底上涨的原因。

The paper introduces the reasons of furnace charge 's rising in the bottom in production Cr-Si alloy .

本文介绍了使用硅铁代替硅铬合金作还原剂，冶炼低碳铬铁的工艺方法。

Abstract The process of smelting low carbon ferrochromium using ferrosilicon as reducer instead of silicochromium alloy is introduced .

GB/T10323-1988铬铁、硅铬合金化学分析方法电位滴定法测定铬量

Methods for chemical analysis of ferrochromium and silicochromium & The potentiometric titration method for the determination of chromium content

GB/T4699.2-1984硅铬合金化学分析方法碱熔-过硫酸铵氧化容量法测定铬量

Methods for chemical analysis of silicochromium & The alkaline fusion-ammonium persulfate oxidation volumetric method for the determination of chromium content

通过生产实践，对用石灰和铬矿洗炉进行了分析，并介绍了洗炉后转炼硅铬合金的方法。

According to the practice , the paper analyzes washing lime and chromite , and introduces the means of tunning Cr-Si alloy after washing furnace .

本文介绍了用固态硅铬合金热兑法试生产微碳铬铁的情况，并讨论了该工艺在实践中存在的问题及改进意见。

The condition of producing extra-low carbon ferrochromium with solid SiCr by perrin process , is introduced the existing problems in practice and opinions for improving for this process are discussed .