刚性轴

ɡānɡ xìnɡ zhóu
  • rigid shaft;rigid axle
刚性轴刚性轴
  1. 在此基础上,利用回弹后曲率半径的主要影响因素即刚性轴半径和进给量,对已有理论结果进行了修正,得到了滚弯回弹理论修正公式,并给出了具体算例。

    On the basis of this using the radius and the feed of the rigid axle which are the main factors of influence on the radius of curvature after springback , a modified bending springback formula has been obtained and an example of calculation given .

  2. 铰接式横梁由关节轴承、轴承座和刚性轴构成,刚性轴与轴承座由关节轴承连接。

    The articulated beam is structured by an oscillating bearing , a bearing chock and a rigid shaft ; wherein the rigid shaft is connected with the bearing chock through the oscillating bearing .

  3. 刚性轴对称狭窄血管内压强及其梯度的研究

    Pressure and Pressure Gradient in an Axisymmetric Rigid Vessel With Stenosis

  4. 灵活性:较小的转弯半径,前刚性轴上较轻的重量。

    MANEUVERABILITY . Short turning radius , less weight on the front axle .

  5. 非刚性轴多刀车削成形过程模拟

    Simulation on Multi-cutting Machining Shaping Process of Non-rigid Shafts

  6. 非刚性轴切削加工振动的数值模拟

    Numerical simulation for cutting vibration of nonrigid shafts

  7. 高强混凝土的单轴抗压力学性能试验研究刚性轴离心式压缩机

    Experimental Investigation of Behavior of High-strength Concrete Under Uniaxial Compression stiff shaft centrifugal compressor

  8. 采用竹帘卷内放置有孔棱的空心刚性轴进行束缚干燥,可以有效提高干燥速度和干燥质量;

    We have adopted the method to place a hollow rigidity axle ( with hole and ridge ) in the bamboo curtain reel to proceed bound drying , which can improve drying velocity and drying quality effectively .

  9. 运用布西内斯库近似,以刚性轴对称直圆管作为血管模型,导出了脉动流所满足的基本扰动方程,并解出脉动流轴向速度和温度的径向分布。

    Based on the Boussinesq ′ s approximation and using an axisymmetric vascular model in rigid tubes , the basic perturbation equations of pulsatile flow , and the radial distribution of the axial velocity and the temperature are derived .

  10. 在二阶频率的正弦载荷作用下,弹性轴轴承系统的最大油膜压力远大于刚性轴轴承系统,而其最小油膜厚度则远小于刚性轴轴承系统。

    When the flexible shaft-bearing system was excited with the second order frequency , the maximum oil pressure was much greater than that of the rigid shaft-bearing system , and the minimum film thickness was much less than that of the rigid shaft-bearing system .

  11. 研究了迥转体转轴刚度和分布质量对轴承动反力的影响,通过对刚性轴与弹性轴轴承动反力的比较,提出了轴承动反力影响系数的概念,得到了若干新结果。

    The effects of the stiffness of rotor shaft and distributed masses on the dynamical reactions of bearing are studied in this paper . By comparing rigid shaft with elastic shaft , elastic effect coefficient of dynamical reaction of hearing is presented , And some new results are aquired .

  12. 三支点刚性搅拌轴的优选与理论分析

    Optimization and Theoretical Analysis of Rigid Shaft in Tri-Point Support

  13. 刚性桩轴力增加,桩土应力比与桩的荷载分担比增大。

    Rigid pile axial force increases , pile-soil stress ratio and the pile load distribution ratio increases . 7 .

  14. 进行了高应力水平的混凝土弯曲疲劳实验,得到了混凝土疲劳方程及刚性路面轴载换算方法;

    According to the concrete fatigue test of high stress ratio , by means of MTS850 test machine , the fatigue equation and the formula of axle load conversion suitable for heavy axle load are obtained .

  15. 防渗墙刚性混凝土单轴及三轴受压的本构关系试验研究

    Test on the constitutive relations of rigid concrete by single-axial and three-axial pressure in diaphragm wall

  16. 文中给出嵌入半空间的受扭的刚性圆柱的轴的表面上的正确的应力分布的检查的例子。

    An example for checking the correct stress distribution on surfaces of twisted rigid cylindrical shaft embedded in a half space is given .

  17. 十字轴刚性万向节从动轴的Matlab仿真研究

    Simulation Based On Matlab Software For The Hooke 's Joint Driven Shaft

  18. 温度对半刚性沥青路面极限轴载的影响

    Effect of Temperature on Ultimate Axle Load for Semi-Rigid Asphalt Pavements

  19. 刚性多支点传动轴主共振分析

    Analysis of main resonance of drive shaft with rigid multi-supports

  20. 刚性路面超限车辆轴载换算关系的探讨

    Study on Axle Load Conversion Method for Overweight Vehicles on Rigid Pavement

  21. 嵌在弹性半空间的刚性变直径圆轴的扭转

    Torsion of Rigid Circular Shaft of Varying Diameter Embedded in an Elastic Half Space

  22. 运动轴的精度决定了机床的精度,并且机床的刚性主要受运动轴的动态特性影响。

    The precision of motion axes determines the accuracy of the machine tool which is mainly influenced by dynamic characteristics of motion axes .

  23. 文章把刚性圆盘和弹性轴段视为同一单元处理,其结果计算更为准确、编程更为简单。

    This paper looks the rigid disc and elastic axis as a unit , it would became more reasonable theoretically and easier to program .

  24. 在不同的环境温度下,通过对典型结构的理论分析,探讨温度变化对半刚性沥青路面极限轴载的影响。

    The effect of temperature on ultimate axle load of semi-rigid asphalt pavement was explored through theoretical analysis on a typical structure at various temperatures .

  25. 分析表明半刚性基层沥青路面轴载换算指数主要与路面结构强度、公路等级和轴重有关,轮压的影响并不明显;

    It is pointed out that the main influential factors to axle exchange index are pavement structural strength , highway class and axle load ; the influence of tyre pressure is not obvious ;

  26. 刚性多支点传动轴的纵向振动无法消除,影响横向弯曲振动的稳定性及振幅,使轴端的花键微动摩擦及磨损,对传动轴的安全性构成威胁的可能性很小;

    And it affects the stability and amplitude of transverse bending vibration , and makes the spline fretting friction-wear . There is little possibility that the longitudinal vibration of a drive shaft will threaten the safety .

  27. 半刚性连接又分为强轴半刚性连接和弱轴半刚性连接,目前对半刚性连接的研究大多集中在强轴连接方面,而关于弱轴半刚性连接的研究较少。

    Semi-rigid connections are divided into the strong axis and minor axis of semi-rigid connections semi-rigid connections , the current study of semi-rigid connections are mostly concentrated in the strong axis connections , but rather on the minor axis of less semi-rigid connections .