粒铁

  • 网络Ferrite
粒铁粒铁
  1. 第二方案以钛精矿为原料,还原后经破碎磁选分离得到粒铁和TiO2富集率为~75%的钛渣。

    The other is wholly feed as ilmenite , then by crushing and magnetic separation after reduction , iron shots and slag , of which the enrichment ratio of titanium oxides could reach by 70 % ~ 76 % , can be gotten .

  2. 高岭土精矿中微量微细粒铁、钛赋存状态研究

    Research on Occurrence State of Trace Fe and Ti in Kaolin

  3. 回转窑内粒铁温度测量

    Temperature Measure of Nodule in Rotary Kiln

  4. 脱碳粒铁&电炉炼钢解决了高炉生铁小型化炼钢的难题。

    Because it can give high technical index and solve the technical difficulty of steelmaking with small scale .

  5. 另外大量之高温塑性变形可以产生较小之肥粒铁晶粒这样可以抵消高温热浸温度所造成之晶粒粗大效应。

    Large amounts of deformation can lead to smaller ferrite grains which can balance the high temperature soaking effect .

  6. 不施氮时营养器官中铁的净输出量和输出率低于施氮,而吸铁量对子粒铁的表观贡献率却高于施氮。

    Compared with high N , Fe export amount and percentage from vegetative organs was lower , while Fe uptake was higher under low N.

  7. 油润滑条件下镍基纳米Al2O3复合刷镀层磨粒的铁谱分析及其磨损机制研究

    Study on Wear Particle and Mechanics of Nickel Matrix Nano-Al_2O_3 Composite Coating with Ferrograph in Oil Lubricated Condition

  8. 理论分析表明:①FSL传感器可对油液中抗磁质磨粒与铁磁质磨粒进行监测:②两种磨粒输出信号的相位相反;

    The theory analysis shows : ( 1 ) the FSL sensor can monitor the diamagnetism and magnetism wear debris in lubricating oil and liquids ; ( 2 ) the export signal of these two kinds of wearing debris is opposite ;

  9. 粗粒的铁将降低二茂铁的产量。

    A coarser grade of iron will lower the yield of ferrocene .

  10. 中国鲎卵黄粒形成铁蛋白标记的研究

    Studies on the ferritin labelled formation of yolk granules of tachypleus tridentatus Lesch

  11. 机器中磨损磨粒的铁谱分析技术因其高效、经济的优点,在机械设备的状态检测、故障诊断和预防性维修等方面都得到了广泛的应用。

    Ferrography analysis technology for wear debris has been applied broadly in many aspects , such as inspection of machine operation state , failure diagnosis and preventive maintenance , because of its advantages of good effect and economical .

  12. 磨粒识别是铁谱磨粒分析的核心。

    The recognition of the wear particle is the core step of the ferrography .

  13. 铁谱技术在机械设备状态监测中得到了广泛的应用,磨粒识别是铁谱分析的一个关键环节。

    Wear debris recognition is important in ferrography technology , which is now widely applied to condition monitoring of machinery .

  14. 磨粒识别是铁谱分析的核心环节,直接关系到磨损状态诊断的正确性。

    The recognition of the wear particle is the core step of the ferrography . The result of the recognition has direct relation to the correctness of the wear condition monitoring for the equipments .

  15. 一种检测润滑油中铁磁性磨粒的仪器&铁磁性磨粒检测仪

    An Instrument for the Inspection of Ferromagnetic Abrasive Particles in Lubricating Oils

  16. 粗粒重选有利于铁矿物的充分回收;

    The gravity separation of coarse ores is favorable for sufficient recovery of iron mineral .

  17. 在矿山相似材料模拟中,相似材料大多数为散粒体,而铁作为一种增加容重的骨料在其中得到广泛的应用。

    In the simulation of mineral-like materials , the most used materials are granular soil , in which iron is usually adopted as a kind of aggregate for increasing bulk density .

  18. 随着强磁选设备的发展,美国研制的铁轮式永磁高梯度磁选机对微细粒级弱磁性铁矿物只有较好的回收效果。

    With the development of the high intensity magnetic separator , the permanent magnetic high gradient separator manufactured by the USA has better result to the micro particles low intensity magnetic minerals .

  19. 研究表明:这种铁锰质结核形成于淹没台地边缘介于浅水和深水型铁锰质结核之间的过渡类型,其特征与浅水铁锰质鲕粒岩及大洋铁锰质结核明显不同;

    Study reveals that : ( 1 ) these nodules forming in drowned platform margin are a transitional type between shallow-water and deep - water iron-manganese nodules , and are clearly different from shallow-water iron-manganese oolites and deep-water pelagic iron-manganese nodules in character .