开关控制系统

  • 网络Switch control system;foot switch
开关控制系统开关控制系统
  1. 基于LIN总线的转向盘上开关控制系统研制

    Development of Handwheel Upper Switch Control System Based on LIN Bus

  2. 基于MSP430单片机的智能同步开关控制系统

    The Control System of Intelligent Synchronous Vacuum Switch Base on MSP430

  3. 通过对有线载波通信的原理和DTMF信号编码的特点的分析,集合PIC单片机的特点,介绍了利用PIC单片机实现对目标负载有线遥控的智能开关控制系统;

    Based on the principle of carrier-current transceiver and coding by DTMF , the intelligent controlling on-off system with this principle and PIC single chip microcomputer is introduced .

  4. 其实让Endy博士更感兴趣的是调节基因表达的开关控制系统。

    In particular , Dr Endy is interested in switches and control systems that regulate other genes .

  5. 复合材料液态浸渗挤压的开关控制系统

    Switch Controll System of Liquid Infiltration and Extrusion Process of Composites

  6. 机务段隔离开关控制系统的改进方案

    Improved Scheme of Control System of Disconnector Used in Locomotive Depot

  7. 基于短消息服务的电气设备开关控制系统

    The Electrical Switch Control System Based on SMS Sweet Service

  8. 基于嵌入式系统的矿用组合开关控制系统的设计

    Design of Control System of Mine-used Assembled Switches Based on Embedded System

  9. 一种无线远程开关控制系统的设计

    Design of a Wireless Remote Switch Control System

  10. 本文介绍了微电脑定时开关控制系统的研制及它的优点。

    The research and manufacture of the Microcomputer time on and off control system and its feature are introduced .

  11. 改进了传统的开关控制系统的控制对象单一性及不能任意设定定时时间的缺点;

    In addition , the sole control target of the traditional on and off control system and its time no being set up freely are improved .

  12. 最后分析光开关控制系统,将其分为控制单元、驱动单元、执行单元和反馈单元四部分。

    Finally , analyzed optical switch control system which can be divided into four parts : control unit , drive unit , actualization unit and feedback unit .

  13. 本文将结合嵌入式技术、传感器技术、工业以太网技术以及自动控制原理,设计矿用隔爆型智能组合开关控制系统,实现分散控制、集中管理。

    This thesis combines Embedded technology , sensor technology , ethernet technology and principles of automatic control , designed an intelligent control system of mine-used flame-proof assembled switch to achieve decentralized control , centralized management .

  14. 基于DSP实现的软开关电源控制系统

    DSP Based Soft-Switch Power Control System

  15. 本文论述了应用可编程序控制器(PLC)的移位寄存器对开关量控制系统的编程方法。

    This paper discusses the programming method of applying shift register of programmable controller ( PLC ) for switching signals control system .

  16. 介绍了PLC特点及其在高压开关设备控制系统设计方面的应用,以实现PLC控制替代传统继电控制的目的。

    Properties and applications of PLC to high-voltage switchgear control system designing is introduced , the applications shows that PLC control could substitute traditional relay control system .

  17. 基于MOEMS技术光开关及控制系统研究

    Research on MOEMS-Based Optical Switch Technology and Optical Switch Control System

  18. 针对传统开关电源控制系统的不可靠性,采用数字控制的方法,用数字信号处理器(DSP)TMS320VC5402设计并实现了全桥软开关电源控制系统。

    Instead of traditional power control system which is unreliable , a soft-switch power control system based on DSP ( TMS320VC5402 ) is designed and realized using digital control method .

  19. 鱼雷电机软开关逆变控制系统谐振匹配策略研究

    Resonant Matching Strategy of Soft-switching Inverter Control System for Torpedo Motor

  20. DGK-可控硅开关程序控制系统的研制

    A dgk thyristor switching programmed control system

  21. 介绍一种电力开关远程控制系统中基于单片机的通信系统协议的设计与实现。

    In this paper , the design and implementation of communication protocol of remote control system for power switch is introduced .

  22. 为了保证开关控制输入系统的稳定性,提出了鲁棒控制不变集的构造方法。

    In order to guarantee the stability of systems with On-Off input , the construction method of robust control invariant sets is proposed .

  23. 延时控制系统是保证爆磁压缩发生器运行的关键部件,介绍了传统平板型开关延时控制系统的工作机制,分析了其优缺点。

    This paper introduced the operating principle of classical timing control system using flat switch along with an analysis of its merits and drawbacks .

  24. 这些保护开关与控制系统配合,可以实现故障报警,故障停机等保护措施,以保证胶带输送机系统的安全。

    The protection switches and control systems can be achieved fault alarm , fault shutdown and other protective measures to ensure the safe of tape transfer systems .

  25. 直线力电机是直线电机的一种,主要是作为执行器应用于电液伺服阀等位置伺服或开关量控制系统。

    As a kind of linear motor , linear force motor usually is used as an actuator in positioning or switching control system for hydrometric servo valves and so on .

  26. 目前快速深拉伸液压机大多采用液压开关式控制系统,它存在着响应速度低、冲击振动大及拉伸件废品率高等问题。

    In most of high-speed hydraulic deep drawing presses , the switch-type hydraulic control system is adopted , and there exist some problems such as the low speed of response , large impact vibration , and the high rate of waste product .

  27. 本文提出了在简单的、程序变化不大的开关量控制系统中,如煤矿地面筛选系统中矩阵式顺控器仍有竞争能力和发展前途。

    In this paper , it is presented that order controller with matrix circuit still has competitive ability and developing future in the simple on-off control system which contains a small number of program , such as the selective system on the ground of coal mine .

  28. 基于ARM的高频开关电源数字控制系统设计

    Design of the Digital Control System of the High Frequency Switching Power Supply with ARM

  29. 其中推块气缸通过气缸座焊接在积放轨道上,接近开关连接逻辑控制系统PLC;

    Pushing cylinder block is fixed on the track through cylinder , close to switching logic control system connecting PLC ;

  30. SPICE在开关电源闭环控制系统中的应用

    Application of SPICE in Loop-locked Control System of Switch Mode Power Supplies