喷雾干燥

Cr3C2-25%NiCr料浆中分散剂含量对其喷雾干燥粉末性能的影响

Effect of dispersant content in cr_3c_2-25 % nicr slurry on powder property prepared by spray drying

溶媒法或喷雾干燥法制备头孢菌素C钠盐

Comparision studies on solvent extraction and spray drying proceses to prepare cephalosporin C sodium

在此基础上，编写了向下并流式喷雾干燥的VISUALBASIC程序。

Based on this , a Visual Basic programme of downwards cocurrent spray drier .

超临界CO2喷雾干燥制备乙基纤维素微粒的实验研究

Experimental study on preparation of microparticles by using supercritical CO_2 spray drying

PLC在喷雾干燥制粒中的应用

Application of PLC in the granulating process with spray dryer

PLC在陶瓷生产喷雾干燥中的应用

The application of PLC in spray and dry section of ceramic production

基于PLC的模糊逻辑控制在喷雾干燥中的应用

Fuzzy Controller Applied in Spraying Dryer Based on PLC

热处理对喷雾干燥制备的Al2O3纳米团聚体粉末的影响

Effect of heat treatment on spray-dried Al_2O_3 nanocrystalline powder

喷雾干燥条件对PVC专用树脂质量的影响

Influence of spray drying condition on quality of special resin

喷雾干燥法合成介孔硅中pH对结构的影响

The effect of pH on the structure of mesoporous silica composed with the method of spray drying

对乳状液采用喷雾干燥法制备IgG微胶囊。

IgG microcapsules were prepared by emulsified / spray drying .

然后采用热均质-喷雾干燥法制备了维生素A、维生素E纳米球/微球双包埋体系。

The vitamins A and E nanosphere / microsphere double-layers encapsulation system was prepared by hot homogenization - spray drying technique .

详细介绍了喷雾干燥技术在PVC糊树脂生产中的应用情况。

The application situation of spray drying technology in the production of PVC paste resin was introduced .

方法：以口蹄疫DNA疫苗为DNA疫苗的模型药物，采用喷雾干燥离子交联法制备DNA疫苗海藻酸钠微球；

Methods : Using foot-mouth-disease DNA vaccine as a model drug of DNA vaccines , DNA-SA-MS was prepared by spray drying and ion cross-linking method .

研究了超临界CO2萃取花椒油，并直接采用同轴喷嘴喷雾干燥制备微胶囊。

Zanthoxylum oil is extracted with supercritical CO_2 and encapsulated by spray drying ( using a coaxial nozzle ) .

TiB2/Al2O3复合粉体的喷雾干燥造粒与特性研究

Study on spray drying and characteristics of tib_2 / al_2o_3 composite powders

为探讨干燥器内流体流动和喷雾干燥传热传质特性，建立了喷雾干燥过程传递微分方程组，用k？

To study the flow fields , and the heat and mass transfer in spray dryer , the differential equations of transfer had been established .

首次采用配置溶胶并进行喷雾干燥来制备（W，Ni，Fe）前驱体复合氧化物粉末。

( W , Ni , Fe ) precursor composite oxide powders were first synthesized by preparation of solution colloid and spray drying .

喷雾干燥工艺制备WO3-CoO复合粉的研究

Study on Preparation of WO_3-CoO Composites by Spray Dry Processing

在转篮式无梯度反应器中对喷雾干燥沉淀铁催化剂进行了Fischer-Tropsch（FT）合成反应研究。

Fischer-Tropsch synthesis has been studies over spray-dried precipitated iron catalyst in a spinning basket gradientless reactor .

采用SEM和TEM分析了ZrO2喷雾干燥粉料颗粒形貌和显微结构。

The morphology and microstructure of ZrO 2 spray dried ( SD ) granules were analyzed by means of SEM and TEM .

简要介绍了喷雾干燥脱硫技术的工艺原理、特点、流程及其在燃煤锅炉烟气SO2控制中的应用。

The technological principle and process of spray dry desulfurization , and its application to flue gas SO_2 control are briefly described .

考察影响葛根胶囊喷雾干燥试验的3个因素分别为：浸膏相对密度（A）、进风温度（B）、出口温度（C），每个因素取3个水平。

The inspection influence Radix capsule spray drying experiment 3 factors respectively are extracts the proportion ( A ), enters the wind temperature ( B ), the outlet temperature ( C ), each factor takes 3 levels .

喷雾干燥法制取VAE粉体工艺技术

Process of VAE Powder Production by Spray - drying Method

以偏钨酸铵（AMT）为原料，采用喷雾干燥法结合氢气还原方法成功制备出球形钨粉。

The spherical tungsten powder was fabricated by spray-drying method combined with hydrogen reduction using ammonium metatungstate ( AMT ) as raw materials .

概述了喷雾干燥制备硬质合金牌号粉末料的工艺过程，给出了控制流程图，着重分析了PLC控制系统的软、硬件原理。

To outline the granulating process of cemented carbide grade powder throuth the spray dryer , present the process control chart , and mainly discuss the hardware and software principle of the PLC control system .

本文研究喷雾干燥法和无机胶化法制得PSZ粉末和陶瓷片，在不同介质及条件下Y2O3的溶解度。

Y_2O_3 solubility in different media and conditions of PSZ powder and ceramic flat prepared by spray drying and inorganic jelling was studied .

在FCC催化剂生产过程中，高岭土浆液粘度会对生产成本、浆液输送和浆液在喷雾干燥成形时雾化及雾粒分布等造成一定程度的影响。

In manufacture process of FCC catalysts , viscosity of kaolin slurry influences the manufacturing cost , handling of the slurry and distribution of catalyst particles in the spray during drying .

通过控制适当的工艺参数，采用喷雾干燥法成功制备了VAE类可再分散聚合物粉末。

One kind of VAE redispersible polymer powders were prepared by the method of spray drying with fit technical parameters .

针对包含大滞后环节的喷雾干燥炉控制质量不佳的问题，提出廉价的串级控制解决方案，在内环与外环均采用通用的PID控制器。

According to the poor control quality of the spray dry stove with big lagging link , a cheap solution by use of cascade control is put forward . The common PID controller is used in both inside and outside loops .