通缝

采用梁-弹簧模型，用数值模拟分析的方法研究了盾构隧道管片在通缝拼装、22.5°错缝拼装和45°错缝拼装方式下的管片力学状态。

A beam-spring model is applied to study the mechanics behaviour of the segment under straight joint assembling , staggered joint assembling with 22.5 and 45 by using numerical simulation method .

采用盾构法修建地铁区间隧道时，单层拼装式衬砌是目前采用的主流形式，而管片拼装方式主要有通缝式和错缝式。

In the course of constructing the interval tunnel of metro with shield tunneling method , single lining assembling plan is popular currently , and it mainly consists of straight joint and staggered joint method .

在很长的墙体中间不但边界出现裂缝，中间亦出现竖向通缝。

There are vertical cracks besides boundary cracks in long infill wall .

蒸压灰砂加气混凝土砌体通缝抗剪强度的试验研究

Experimental Study on Shear Strength of Autoclaved Aerated Sand Lime Concrete Masonry Walls

提出了带竖向通缝的建筑模网混凝土剪力墙，并对其基本性能进行研究。

Study the basic behavior on Building Formwork concrete shear wall with vertical seams .

通过对砌体的沿通缝抗剪试验研究，得出了其抗剪破坏特征、抗剪强度；对其抗剪强度的计算公式进行了回归分析，并提出了相应的建议公式。

Based on the experimental research of shear strength , we get its shear destructive characters and shear strength ;

盲孔多孔砖砌体的通缝抗剪强度略低于规范计算值，为保证结构安全，建议设计时乘以系数0.9；

The shearing strength of back covered porous brick masonry is slightly lower than the Standard level . A coefficient of 0.9 can be multiplied to ensure the safety of structures .

软件考虑了各种可能的线性和非线性模式以及规范验算方法，实现了计算的图形化输入，适用于管片通缝和错逢拼装计算。

The software provides the various possible linear and nonlinear models as well as verification for segment design specification , and is suitable for two segment assembling types with the straight joint and the staggered joint .

试件设计成两组，其中一组沿齿缝弯曲，另一组沿通缝弯曲。

The specimens are designed into two different groups , one group of which subject to bending around axis parallel to bed joint orientation , and the other subject to bending around axis normal to bed joint orientation .

本文通过对伊通加气混凝土砌体12个轴压和偏压试验、18个弯曲抗拉试验和9个通缝抗剪试验的结果进行分析，研究了采用专用粘结剂砌筑的伊通加气混凝土砌体的基本力学性能。

In this paper , the basic mechanical behavior of Yitong concrete masonry adopting special paste has been studied by the analysis of 12 test of axial bearing and eccentric bearing , 18 tension test of bending , and 9 shearing test of through suture masonry .

苏通大桥主桥伸缩缝采用异型钢与单元橡胶密封带组合的模数式结构。

Sutong bridge adopted a module structure combined with deformed steel and unit rubber polymer as expansion joint .