输出信号

可接收各种类型X、γ射线探测器的输出信号；

The Multi-Channel Analyzer can incept all kinds of X and y detector output signal ;

线阵CCD视频输出信号傅里叶分析与滤波参数设计

Fourier Analysis of Video Output Signal of Linear CCD and Filter Parameter Design

线阵CCD输出信号相关双取样处理技术探讨

A Correlative Double Sampling Processing Technique for the Output Signal of Linear CCD 's

运动热钢坯测量系统中二值化CCD输出信号的模拟

The Simulation of the Binary CCD Output Signal in Size Measuring System for Moving Hot Steel Slab

CCD输出信号处理

Processing of CCD output signal

本文讨论和分析了零件尺寸检测系统中所用CCD的输出信号，并探讨了在该系统中CCD主要参数的选择原则。

This paper is intended to analyze the output signal of CCD used in size detecting systems .

PLC主控单元根据控制要求列出输入输出信号并标出代号。

The main control unit of PLC listed I / O signals and marked designations according to the control request .

PLC为主控单元，完成系统的主要控制过程、数据处理以及输入输出信号的配置。

PLC is control unit which completes main process and data processing and the configuration of input and output signals .

采用DMA技术高速采集摄像CCD输出信号

A High-Speed Data Acquisition System for Output Signals from Imaging CCD by DMA Technique

分析了CCD器件输出信号与光积分时间、CCD驱动频率和后续低通滤波器之间的关系。

Relationship of the CCD output signal and optical integration time , and relationship of CCD driving frequency are described .

利用SYSTEMVIEW仿真软件，对系统功率代价进行分析，仿真结果表明，该偏振模色散补偿系统使输出信号的质量大为改善。

Through the analysis of system power penalty using System View software , the result can be obtained that using the compensation system mentioned above , the quality of the output signal can be improved greatly .

随机噪声是影响CCD器件输出信号信噪比的主要因素，它包括1/f分形噪声和白噪声。

Stochastic noises in CCD output signal , which contain 1 / f fractal noises and white noises , mostly affect the Signal-to-Noise .

给出了利用系统的输入输出信号计算Volterra核矩阵的公式。

The calculating formula of Volterra kernel matrices using input and output signals are presented .

其功能是通过放大、V／F转换、隔离和计数，把色谱仪的模拟输出信号转换成16位或24位的数字量信号（由程序选择）。

The card can convert analog output of chromatograph into 16 - or 24-bit digital signal after amplifying , V / F converting , isolating and counting .

该模拟源由软件、硬件平台两个模块组成。软件模块的功能是生成星载SAR分布目标原始数据，而硬件模块的功能是实时的把离散的原始数据转换成模拟的射频输出信号。

The raw signal simulator , which could generate the real-time echoes of distributed target , is divided into two parts : software and hardware platforms .

对Moore机而言，其输出信号只与状态有关，而与输入信号无关。

For the Moore automation the output is only related to the state not to the input signals .

为提高电动助力转向（EPS）系统控制的精度，必须对传感器的输出信号进行动态补偿。

In order to increase the control accuracy of EPS , dynamic compensation must be made to output signals of sensors .

以CCD的结构及工作原理为出发点，详细分析了输出信号所附各种噪声的产生原因，找出了主要噪声。

According to CCD structure and working principle , the emergence reasons of attached to the output signal noise are analyzed carefully to identify the main noise .

在研究SSR信号体制、特性的基础上，分析A、C模式空管应答机的输入输出信号特性，研制基于单片机的A、C模式空管应答机的检测系统。

Based on the research SSR signal rule ? works characteristic 's foundation , analyze A ? C mode of aviation administer transponder IN / OUT signal characteristic , develop A ?

用平方律探测器面阵CCD记录谱面的联合变换功率谱，功率谱经光学傅立叶变换，得到相关输出信号；

The CCD matrix camera as square law detection records joint transform power spectrum in spectrum space . Through optical Fourier transform , we can gain correlation signal ;

通过对DDS输出信号的频谱特性分析，设计了两种滤波器对信号进行滤波处理。

According to analyzing the output signals ' characteristics of frequency spectrums , two kinds of filters are designed to filter signals unwanted .

通过对电荷存储和CCD信号注入方法的介绍，阐述了CCD的工作原理，并研究了CCD系统的性能参数对CCD输出信号的影响。

Through the introduction of the electric charge saving and the introduction of the infusing method with the signal of CCD , the paper expatiates the CCD working principle .

通过预装的霍尔位置传感器和增量式编码器的输出信号，DSP采用粗精两级磁极搜索方法，获得转子磁极的精确位置，并缩短了搜索过程。

A rough and refined two level pole position search method was implemented to identify the rotor magnetic pole position according to the readout of an incremental encoder , and hall sensors .

本系统将视频摄像部分的数字输出信号通过USB端口传送至嵌入式系统开发板，并将视频内容通过LCD显示。

The system has transmitted the digital output signal of video recording part to embedded system development board through USB port , and displayed video content through LCD .

锁相环（Phase-LockedLoop，PLL）是一种使输入参考信号与输出信号在相位和频率完全一致的同步电路。

The Phase-Locked Loop ( PLL ) is synchronizing circuit which can make the input reference signal exactly consist with the output signal in phase and frequency .

分析研究了CCD输出信号的噪声成分和相应的抑制方法，针对已有的相关双采样电路的局限性提出了一种基于数字技术双采样的方法来降低信号噪声。

Through the analysis about the noise composition and corresponding suppression measures , a double sampling method based on digital technique is presented in allusion to the limitation of existing methods .

系统输出信号的偏振度（DOP）反映了系统的偏振模色散。

The degree of polarization ( DOP ) of optical signals is related to the PMD of the system .

假定输入为单频正弦光栅，对刷扫工作状态下线列CCD输出信号的频谱进行了分析。

For a linear array CCD in a push-bloom imaging system , on condition that the input signal is a sine pattern with single frequency , the output signal spectrum is analysed .

在各种高精度线阵CCD应用系统中，需要对像元输出信号进行快速采样、存储及数据处理。

There is need to carry on sampling , storing and data processing quickly of output signal from image cell in various kinds of the application system of high accuracy linear CCD .

完成了对各个传感器如GPS、电子罗盘、绝对光码盘的数据采集，以及对电机驱动器控制信号与输出信号的控制。

The data collection for various sensors such as GPS , electric compass and code disc has been completed , and the control over the controlling and output signals of the motor driver has been realized .