轴心受压

  • 网络axial compression
轴心受压轴心受压
  1. 焊接H形钢轴心受压柱截面优化设计

    Cross-sectional Optimization Design of Steel Axial Compression Columns with Welded H-shaped Cross-sectional

  2. 考察Q460高强等边角钢在轴心受压和两端偏心受压下的破坏形态和极限承载力,并且将ANSYS的分析结果和试验结果对比分析。

    The failure mode and ultimate bearing capacity under axial compression and eccentric compression are studied . The results of ANSYS are also compared with the test results .

  3. 色谱条件:色谱柱为C(18)柱;基于最优设计的轴心受压钢筋砼截面计算方法

    The Calculation Method of the Axially Compressed Reinforced Concrete Column Section Based on Optimum Design

  4. H型截面轴心受压钢构件限制失稳的基本理论研究

    The Basic Theoretical Study of H-section Axial Compressed Steel Member in Confined Buckling

  5. 轴心受压H型截面钢柱火灾行为的试验研究

    Experimental Investigation of the Behaviors of Axially Loaded H-Section Steel Column under Fire

  6. 火灾下轴心受压H型截面约束钢柱整体稳定设计

    Overall Stability Design of Restrained H-Section Steel Columns under Axial Load in Fire

  7. 加大截面加固RC轴心受压构件的强度计算

    Strength calculation of axial compressive RC members strengthened with increasing section method

  8. CS墙板轴心受压承载力的试验研究

    Experimental Study on the Axial Compression Strength of CS Wall Slabs

  9. 轴心受压FRP约束圆形混凝土柱应力-应变模型

    Stress-strain model of FRP-confined circular column subjected to axial compression

  10. 用外包钢筋混凝土方法加固RC轴心受压柱的承载力计算

    Calculation of load carrying capacity of axially compressive RC columns strengthened with enclosed reinforced concrete

  11. FRP约束方形混凝土柱轴心受压强度模型

    Model of axial compressive strength on the square concrete column confined by FRP

  12. FRP布约束混凝土方柱轴心受压性能的有限元分析

    Behavior of FRP-confined concrete square columns under uniaxial loading

  13. 不同FRP约束混凝土圆柱轴心受压性能试验研究

    Experimental research of properties of circular-columns in different FRP shells under axial compression

  14. CFRP约束砼短柱轴心受压状态下的试验研究

    Experimental study about short concrete column limited with CFRP under axial load

  15. CFRP加固轴心受压混凝土方柱的承载力计算

    Calculation of Bearing Capacity of Axial Compressed Concrete Column Reinforced with CFRP

  16. 轴心受压FRP约束钢筋混凝土圆柱的承载力计算方法

    Axial Compressive Capacity of FRP Confined Circular Columns

  17. SRC柱轴心受压承载力计算公式

    The Calculations of the Axial Load Bearing Force of SRC Column

  18. CFRP加固高强混凝土柱轴心受压性能试验研究

    Test Study on Mechanical Performance of High-strength Concrete Column Confined by CFRP under Axial Load

  19. 高性能GFRP包裹RC方柱的轴心受压试验研究

    Experimental research on RC square columns wrapped with high performance GFRP under axial compressive load

  20. GFRP组合RC柱轴心受压的试验研究与分析

    The Experimental Researches and Analysis about the Axial Compress of RC Columns Combined with GFRP

  21. FRP加固实心黏土砖短柱轴心受压试验研究

    Experimental study of the axial compression of short columns of solid clay bricks strengthened with FRP sheets

  22. 莱钢产轧制H型钢构件受力性能的理论与试验研究(Ⅲ)H型钢轴心受压构件极限承载力的试验研究

    Study on the mechanical property for rolled H-shaped steel members produced by laigang (ⅲ) study on the ultimate strength capability for axial compressed rolled H-shape columns test

  23. GFRP管轴心受压性能的试验研究

    Experimental Study on GFRP Pipes Under Axial Compression

  24. 纤维布(FS)约束混凝土矩形柱轴心受压试验及非线性有限元分析

    Experimental study and 3-D nonlinear finite element analysis of axially loaded fiber sheet confined rectangular concrete columns

  25. GFRP管钢骨高强混凝土组合柱轴心受压试验研究

    Experimental research of GFRP tube columns filled with steel-reinforced high-strength concrete subjected to axial loading

  26. 采用能量法推导出FRP加固轴心受压钢管的弹性屈曲荷载计算公式。

    The elastic buckling load of axially loaded compression steel pipes strengthened with FRP was presented in this paper by using energy approach .

  27. 本文的主要工作如下:(1)对两种不同支承条件(两端铰接,一端固定另一端铰接)下的H型截面轴心受压钢构件的限制失稳问题进行了理论分析。

    Firstly , buckling load of H-section axial pressure structures is studied aim at two different conditions of support : both ends are hinged and one end is hinged but the other is rigid connection .

  28. CFRP加固混凝土轴心受压构件的研究较多,理论较成熟,已有相关规范和计算公式。

    Thirdly , there are some mature theorys and studys for CFRP reinforced Axially loaded concrete components , also have been relevant norms and calculation formulas .

  29. 钢结构设计规范对热轧H型钢剖分T型钢轴心受压杆件腹板高厚比的限值做了修订。

    Revisions are made for the limitation of width to thickness ratio of cut T-type web subject to axial compression in the design code for steel structures , in which the assumptions for the theoretic deduction are not conservative enough .

  30. 为建立纤维增强复合材料(FRP)约束圆柱混凝土受压应力-应变关系模型,分析了国内外305个轴心受压FRP约束混凝土圆柱试件的试验结果。

    To develop a compressive stress-strain model for fiber reinforced polymer ( FRP ) confined concrete , the test results of 305 axially loaded FRP confined concrete cylinder ( FCC ) specimens are analyzed .