转变温度

非晶态超导体转变温度Tc的经验公式

An empirical expression of transition temperature t_c for amorphous superconductors

高温超导体反铁磁转变温度TN的理论计算

Theoretical Calculations of Antiferromagnetic Phase Transition Temperature T_N for High Temperature Superconductor

PET玻璃化转变温度处双重吸热峰的研究

Study on the Double Endothermic Peaks at T_g of PET

负U中心模型的超导转变温度及同位素效应

Superconducting Transition Temperature and Isotopic Effect of a Negative U Center MOdel

如果T比转变温度低，情况就相反，偏T偏p大于零。

If T is less than T inversion , you have the opposite case , and dT / dp is greater than zero .

DSC分析显示玻璃化转变温度提高了3·54%。SEM观察断裂面为韧性断裂。

SEM showed that the surface of rupture was tough .

采用差热分析仪测定不同锑含量的Fe－C－Si－Mn合金的共晶转变温度。

DTA was used to determine the eutectic transformation temperature of the alloy with varying antimony content .

冲击功与COD转变温度的相关关系

A Correlation Between Transition Temperatures of Absorbed Energy and Fracture Toughness , COD

调制示差扫描量热法测定ABS树脂玻璃化转变温度

Measurement of Glass Transition Temperature of ABS Resin by Modulated Differential Scanning Calorimetry

其囫囵电子相发生相变的温度就是该超导体的超导转变温度TC。

The superconducting temperature TC is the temperature at which the phase change occures .

应用玻璃化转变温度评价SBS改性沥青低温性能

Evaluation for Low Temperature Performance of SBS Modified Asphalt Using Glass Transition Temperature

结果表明，这三种金刚石的脆－塑性转变温度的顺序为：Ⅰb＜Ⅰa＜Ⅱa。

The results show that the order of brittle ductile transition temperature for the three kinds of diamond is : ⅰ b < ⅰ a < ⅱ a.

DSC表明此高分子染料在55℃有一个玻璃化转变温度。

DSC analysis showed that the PU-DBG has a single glass transition temperature of 55 ℃ .

DCS谱图显示高吸水纤维具有两个玻璃化转变温度区间，表明在高吸水纤维内形成了相分离。

DSC showed there were two glass transitions and phase interface came into being in the superabsorbent fiber .

HTPB/增塑剂共混物玻璃化转变温度的MD模拟

Molecular dynamics simulation on the glass transition temperatures of HTPB / plasticizer blends

差示扫描量热（DSC）测定了热塑性淀粉的玻璃化转变温度。

The glass transition temperature ( Tg ) was determined by differential scanning calorimetry ( DSC ) .

用DSC测量葡萄糖溶液部分玻璃化转变温度的新方法

A New Method for Measuring the Glass Transition Temperature of the Maximally Freeze-Concentrated Glucose Solution by DSC

树脂玻璃化转变温度对GFRP拉/压性能的影响

Effects of Resin Glass Transition Temperature on Tension / Compression Properties of GFRP

研究表明，PAN嵌段长度对PEO的熔点、PAN的玻璃化转变温度有很大的影响。

The effect of PAN block length on the thermal properties of PEO and PAN was also study .

HAN-TEAN-H2O三元体系的玻璃化转变温度的依数性和微观结构的推测

The Colligative Property of Glass Transition Temperature and the Inference of the Microstructure for the Ternary System of HAN TEAN H_2O

用DSC、偏光显微镜及X射线衍射等研究了这些聚合物的液晶相转变温度及相行为。

The liquid crystalline properties of the polymers prepared were also investigated by differential scanning calorimetry ( DSC ), polarizing microscopy and X-ray measurement .

AgI（α-Fe2O3）复合离子导体相转变温度相互影响的研究

Mutual effect on phase transition temperatures of two phases in agi (α - fe_2o_3 ) composition electrolytes

Al-Si合金在液相线以上存在铝、硅原子集团的结构转变温度区间。

There are structure transformation temperature intervals of Al and Si atom clusters above liquidus line of Al-Si alloy .

通过比较不同温度下的S（Q）峰位和强度，我们发现S（Q）的强度随着温度的变化有一突变，这一突变温度对应于玻璃转变温度。

The intensity of S ( Q ) has a sudden change of slope with the increasing of temperature . This point is corresponding glass transition temperature .

该文研究了具有不同Tl缺位的Tl－2223和Tl－2212超导体的结构和超导转变温度的时效稳定性。

Abstract The stability of time effects of Tl-2223 and Tl-2212 superconductors with a different deficiency has been investigated .

在一定参数范围内，这种夹层系统的Tc是有可能高于大块BCS超导体的转变温度。

The transition temperature of this kind of sandwich is probably higher than the T_c of the bulk BCS superconductor within certain range of parameters .

玻璃化转变温度（Tg）决定了高聚物的基本性能，而通过共聚可以改变聚合物的玻璃化转变温度。

Glass transition temperature ( Tg ) determines the basic properties of polymers . Polymers ' glass transition temperature can be changed through copolymerization .

应用熔点和玻璃化转变温度这两项高分子材料的重要指标对麦秸与EVA、PE、PVC之间的热反应特征进行分析，可以了解它们之间的反应状况。

The reaction status can be known between wheat straw , EVA , PE and PVC by the hot-reaction analysis of melting point and vitrification temperature Tg .

TMP对8190PU/PVC体系的阻尼性能最大的影响是提高了体系的玻璃化转变温度。

The greatest impact of TMP on the 8190PU / PVC system was to improve the glass transition temperature .

同时，加入增塑剂，还可以降低塑料在熔融态时的粘度、弹性模数及玻璃转变温度（tg）。

The addition of a plasticizer may lower the melt viscosity , elastic modulus , and glass transition temperature ( Tg ) of a plastic .