硫化反应

  • 网络sulfurization
硫化反应硫化反应
  1. 在硫化反应中生成原位SiO2。

    Preparing in-situ silica during curing .

  2. 结果表明,在硫化反应前期,硬质SBR胶料中交联结构起主导作用;

    The results showed that the crosslink structure in SBR ebonite compound was predominant at the early stage of vulcanization ;

  3. 利用SEM的能谱扫描功能,对钠盐调质脱硫剂硫化反应产物断面元素分布进行了分析。

    The distribution of elements at the sulfidation reaction product section of a sodium salt-modified desulfurization agent was analyzed by using the energy-spectrum scanning function of SEM .

  4. 通过元素分析、红外光谱、XPS能谱、XRD分析、DSC/TG分析、扫描电镜等多种现代分析手段表征了复合材料的结构和成分,并研究了单质硫催化聚合物脱氢硫化反应的机理。

    The structures and components of the resulted composites were characterized by FTIR , XPS , XRD , SEM , element analysis and DSC / TG .

  5. 在硫化反应中后期,胶料中交联结构减少,极性的硫环分子对橡胶改性起主导作用,从而形成具有塑料性质的硬质SBR;

    The crosslink structure reduced , and the modification of rubber by polar sulfur ring was predominant resulting in plastics-like SBR ebonite at the middle and final stages of vulcanization ;

  6. 在总结已有模型的基础上,考虑到CaO孔隙结构参数在反应过程中的变化,提出了CaO硫化反应的特定层数晶粒模型。

    New concepts for estimating the sulfation of CaO at high temperatures , namely a subgrain layer model , are presented in this paper . In the model the change of pore structure of CaO during the reaction process has been considered .

  7. 经4h过硫化反应后,TBSI/TMTD体系的300%定伸应力保持约80%,而NS不足60%。

    The ability of vulcanization reversion resistance of TBSI / TMTD was better than that of NS . After 4h over cure , their modulus at 300 % elongation was retentive of about 80 % and less than 60 % respectively .

  8. 在O2/CO2气氛中,因较高CO2浓度使石灰石的煅烧分解推迟,一定条件下石灰石直接与SO2发生硫化反应,且过程具有较高的反应速率。

    In an O_2 / CO_2 atmosphere , because the relatively high CO_2 concentration retards the calcination decomposition process of limestone , the latter , under certain circumstances , enters the CaCO_3-SO_2 sulfation reaction directly , and in addition . does so with a relatively high rapidity .

  9. 碱木素硫化反应以及木素酚醛树脂固化性能的研究

    Sulfuration Reaction of Soda Lignin and Adhesion Properties of Lignin-phenol-formaldehyde Resin

  10. 反应条件和脱硫剂类型对硫化反应影响也很大。

    The reaction conditions and sorbent type affect the reaction greatly .

  11. O2/CO2气氛下石灰石煅烧与硫化反应研究

    Calcination and desulfurization of limestone under o_2 / co_2 atmosphere

  12. 动态硫化反应条件下聚合物熔体粘度与本构方程的计算

    Calculation of Viscosity and Constitutive Equation of Polymer Melt under Dynamically Vulcanization

  13. 钙基脱硫剂硫化反应产物层扩散机理研究进展

    Research Development on the diffusion in Sulfidation Reaction Product Layer of Cabased Sorbents

  14. 硅橡胶硫化反应场的数值模拟

    Numerical Simulation of Vulcanization Field of Silicone Rubber

  15. 两种含硫添加剂与金属铁表面硫化反应速度的研究

    Study of Velocity of Sulfide Reactions Between Iron Surface and Two Additives Containing Sulfur

  16. 道路沥青的硫化反应

    Reaction between sulfur and asphalt for pavement

  17. 讨论了硫化反应活化能与并用胶性能之间的关系。

    The relationship between the activation energy of vulcanization and the properties of blend was discussed .

  18. 结果表明:脱硫剂中不可进入孔隙的形成主要出现在硫化反应的开始阶段;

    Results show that the formation of inaccessible pores occurs in the initial reaction stage mostly ;

  19. 其对硫化反应的影响使硫化胶交联密度提高,动态损耗降低。

    An effect on vulcanization results in a higher cross-link density and thus a decrease in dynamic loss .

  20. 探讨长方体胶块和轮胎硫化反应热对硫化温度场的影响。

    The influence of curing reaction heat on curing temperature field of cubic rubber block and tire was investigated .

  21. 调质脱硫剂硫化反应产物层固态离子扩散机理的研究

    An Investigation of the Mechanism of Solid-state Ion Diffusion in the Sulfidation Reaction Product Layer of a Modified Desulfurization Agent

  22. 同时给出了主要配合剂吸水树脂与膨胀率的关系。确定了最佳的硫化反应条件。

    Mean while , the relationship between water-absorbent resin and expanding rate was given and the optimum condition for sulphuration was determined .

  23. 经分析可知,MAA-Zn还可以降低硫化反应活化能、提高硫化胶的交联密度和耐热老化性能。

    MAA-Zn could also decrease the activation energy of vulcanization , and increase the crosslinking density and the resistance to heat aging of vulcanizate .

  24. 在几种主要的模型中,晶粒模型因其显著的优点更适用描述钙基脱硫剂的硫化反应,并对我国的煤气脱硫的前景进行了预测。

    The grain model was suited for describing the complex reaction and the prospect of the technical route of sulfidation in China was discussed in brief .

  25. 为寻找钙基材料最佳固硫反应温度存在的原因,在对其硫化反应过程进行分析的基础上,对贝壳和石灰石的微观结构特性进行了实验研究;

    In order to find out the reason why there is a optimal desulphuration temperature of calcium-based materials , the microstructure characteristics of shell and limestone have been studied .

  26. 结果表明:添加助交联剂TAIC发泡试样的硫化交联反应速度V加快,硫化指数CCRI和交联反应活化能E变大;

    The result showed : curing reaction rate V of foam materials adding assist crosslinking agent TAIC accelerated , curing rate index CCRI and activation energy E increased .

  27. HCI-KCIO3法氧化硫化银反应产物之研究

    Study on the products from the oxidation of silver sulfide with hcl & kclo_3

  28. 介绍了加氢催化剂预硫化的反应原理,探讨了在预硫化过程中影响催化剂预硫化效果的因素。

    It introduced the principal of presulfuration of hydrogenation catalyst and discussed the factors that affected the effect of presulfuration in presulfiding process .

  29. 介绍HCl&KClO3法氧化硫化银反应的检测,以确立该反应方程式的研究工作。

    A study on the determination of the products from the oxidation of silver sulfide with HCl-KClO_3 to establish the reaction equation was presented .

  30. 巯基乙酸钠中两个极性基团一COOH及&SH具有同硫化矿强烈反应的特性,是代替氰化钠抑杂的理想药剂。

    - COOH and - SH two polar groups in mercaptoacetic sodium acid have properties of strong reaction to sulphide ores . It is the most satisfactory agent for replacing sodium cyanide to suppress impurities .