电子负载

一种基于DSP的数字电子负载设计方法

A DSP-based Digital Electronic Load Design Method

其次，针对一种需要进行老化测试的LED恒流驱动电源，给出了一个能馈型电子负载的工程实例。

Secondly , an inverter-based energy-regenerative electronic load prototype is built to facilitate the burn-in test for a constant-current LED driver .

首先分析了能馈型电子负载的系统结构，基于现有的能馈型电子负载方案，提出了一种新思路：H桥级联多电平结构。

Basing on the existing energy feedback electronic load , a new method is proposed : the H-bridge cascaded structure .

基本上实现了UPS放电通过电子负载向电网馈电的功能。

The system basically realizes the function that the energy discharged by UPS is transferred back to AC power network .

采用LCL滤波器并网的交流电子负载

AC Electronic Load Adopting LCL-filter Connected to the Grid

整个测试系统包括交流源电路、信号采集与调理电路、LED电子负载电路、ARM处理器控制电路、液晶显示接口电路、开关量接口电路和通信接口电路。

The whole test system includes AC source , signal acquisition and regulate circuit , LED electronic load , ARM control circuit , LCD interface circuit , switching value circuit and communication interface circuit .

给出了能馈型电子负载系统的主电路图，说明了设计规格，并通过MATLAB仿真试验证明了设计的可行性。

The main circuit diagram of energy feedback electronic load is proposed , and explains the design specifications , and design feasibility was proved by MATLAB simulation . Finally , the paper analysis the reliability of system design .

根据电流控制技术的特点，着重介绍用PWM电流调制技术实现航空蓄电池恒流放电的新型电子负载和航空蓄电池两阶段充电控制电路。

Based on the characters of the current controlled technique , the author presents a new electronic load for constant current discharging and a two steps charging circuit for aviation batteries using PWM current controlled two state modulation technique .

本文根据PWM控制电压逆变器的原理，设计了一种基于80C196KC单片机的新型单相电子负载系统。

This paper presents the design of a new style single-phase electronic load system based on80C196KC single-chip microcomputer according to the principle of PWM control voltage inverter .

设计电子负载的显示菜单，合理规划Flash存储区域，制定各种测量模式下负载的调整策略以及档位切换的策略。3、各种负载模式的设计，尤其是LED模式的实现方法。

Design the menus of E-load , plan the flash storage area , make the adjusting strategies for each mode of E-load , and the strategy of range switch . 3 、 To design all kinds of load modes , especially the implementation method of LED mode .

随着汽车上电器及电子负载的增加以及未来汽车发展的需要，提升汽车电源电压到42V已经势在必行。

Due to the increase of electric power loads in today 's vehicles , the 42V power system has been considered and is being developed to replace the existing 14V power system .

CH8700程控直流电子负载系列可广泛运用于电源变压器，充电器，开关电源，蓄电池等行业的在线测试与实验室等试验领域。

CH8700 program DC electronic load series can be widely applied in on-line test and lab of power transformer , charger , switch power , storage battery industries .

电子负载用软开关DC/DC变换器的实现

Realization of Soft-Switching DC / DC Converter Used by Electronic Load

最后，进行了电子负载的软硬件设计和初步实验。

Finally , hardware and software of the electronic load is designed .

电子负载的研制8毫米高功率电调振荡器

Electronic load the development of Ka-band high power electronic - tuning oscillator

大功率电力电子负载并网变换器的设计与改进

Design and Improvement on the Grid Connection Converter of Power Electronic Load

电能反馈型电子负载的设计与实现

Design and realization of energy feedback type electronic power load

航天器地面供电及检测设备中的电子负载模块

The Electronic Load Module in Space Flyer Ground Supplying and Testing Equipment

基于电驱动钻机的交流电子负载的研究

Research of AC electronic load based on electric drilling dril

多功能电子负载在电子设备测试中的应用

The Application of Multi-functional Electronic Load in the Test of Electronic Devices

几种电子负载校准方法探讨

The Discussion About some Calibration Methods of Electronic Load

航空发电机测试用交流电子负载的研究

Research on AC Electronic Load for Aviation Generator Testing

有源逆变在大功率电子负载上的应用

Application of active inverter to power electronic load

内置电子负载能方便的进行空、载转换测试。

Built-in electric load can make the instrument conveniently perform idling / load conversion .

同时，它亦可以作为一种馈能型电子负载，实现电能的重复利用。

Meanwhile , this equipment can also be used as feedback type electronic load .

方法通过改变电子负载测定输出电压和电流，利用电压/电流密度画出极化曲线。

We got the voltage / current density polarisation curve by changing electronic load .

电子负载监控系统单元控制器的设计实现

The Design and Realization of the Cell Controller for Monitoring System of Electric Load

实时调节型直流电子负载的设计与实现

Design and implementation of real-time regulation electronic load

电流调制技术在电子负载和两阶段充电中的应用

Application of Current Modulation Technique for Electronic Load and Two Step Charging of Aviation Battery

论述了电子负载模块技术在航天器地面供电及检测设备安装调试中的研究与最新应用。

Introduced the latest application of electronic load module used in ground supplying and testing equipment .