玻璃化转变温度

  • 网络glass transition temperature;glass-transition temperature;dsc;t g
玻璃化转变温度玻璃化转变温度
  1. 结果表明:在环境温度高于玻璃化转变温度时,涂层抗介质渗透能力差;

    Experience results show : ( 1 ) When the medium temperture is higher than T g , epoxy powder coating resistance to corrosion medium is worse .

  2. 在环境温度小于玻璃化转变温度时,涂层抗介质渗透能力强.红外涂料对通电电阻带工况的影响

    When the medium temperature is lower than T g , Epoxy powder coating resistance to corrosion medium is better . Effects of IR Coating on the Resistance

  3. 板栗淀粉的晶型属于C型,板栗淀粉的玻璃化转变温度为147.7℃。

    The crystalline pattern of Chestnut starch was C and the glass transition temperature was 147.7C .

  4. PET玻璃化转变温度处双重吸热峰的研究

    Study on the Double Endothermic Peaks at T_g of PET

  5. 聚酯(PET)在超临界二氧化碳中溶胀玻璃化转变温度模型研究

    Modeling of the glass transition temperature of swelling PET in supercritical carbon dioxide

  6. DSC分析显示玻璃化转变温度提高了3·54%。SEM观察断裂面为韧性断裂。

    SEM showed that the surface of rupture was tough .

  7. 高聚物玻璃化转变温度和分子参数的关系Ⅰ.高聚物链柔性与Tg的关系

    Relationship between glass transition temperature ( tg ) and molecular parameters of polymers I.Effect of chain flexibility on TG

  8. 调制示差扫描量热法测定ABS树脂玻璃化转变温度

    Measurement of Glass Transition Temperature of ABS Resin by Modulated Differential Scanning Calorimetry

  9. T30S与PET的两相相容性较差,复合后两相的熔点和玻璃化转变温度变化不大。

    After being composited , the melt temperature and glass transition temperature of two phases changed little .

  10. HAN-H2O二元体系玻璃化转变温度的依数性及其突变

    The Colligative Property of Glass Transition Temperature and its Sudden Change for HAN H 2O System

  11. 应用玻璃化转变温度评价SBS改性沥青低温性能

    Evaluation for Low Temperature Performance of SBS Modified Asphalt Using Glass Transition Temperature

  12. 复合材料的玻璃化转变温度(Tg)随纤维用量增加而增大。

    The composite 's glass transition point ( Tg ) increased with the fiber content .

  13. 通过测定SA的玻璃化转变温度,证明SA二元共聚物的热稳定性良好。

    The glass transition temperature of SA indicated that SA has good heat stability .

  14. 固化后的树脂表现出良好的热性能,热分解温度及玻璃化转变温度(Tg)都较高,柔性结构对玻璃化转变温度的降低有一定的影响。

    The cured resins exhibit high thermal degradation temperatures and glass transition temperatures ( Tg ) .

  15. DSC表明此高分子染料在55℃有一个玻璃化转变温度。

    DSC analysis showed that the PU-DBG has a single glass transition temperature of 55 ℃ .

  16. DCS谱图显示高吸水纤维具有两个玻璃化转变温度区间,表明在高吸水纤维内形成了相分离。

    DSC showed there were two glass transitions and phase interface came into being in the superabsorbent fiber .

  17. 当分子量较大时,AC芯片量热仪测得的薄膜玻璃化转变温度不随膜厚的改变而变化。

    When the molecular weight is large , the glass transition temperature detected by AC chip calorimeter is independent of the film thickness .

  18. HTPB/增塑剂共混物玻璃化转变温度的MD模拟

    Molecular dynamics simulation on the glass transition temperatures of HTPB / plasticizer blends

  19. DSC结果表明聚氯乙烯/有机蒙脱土纳米复合材料的玻璃化转变温度Tg降低,聚氯乙烯/有机蒙脱土比聚氯乙烯/钠基蒙脱土复合材料的力学性能优异。

    Mechanical property testing indicated that the PVC ! Org-Mont nanocomposites were better thanPVC / Na-Mont composites .

  20. 差示扫描量热(DSC)测定了热塑性淀粉的玻璃化转变温度。

    The glass transition temperature ( Tg ) was determined by differential scanning calorimetry ( DSC ) .

  21. 用DSC测量葡萄糖溶液部分玻璃化转变温度的新方法

    A New Method for Measuring the Glass Transition Temperature of the Maximally Freeze-Concentrated Glucose Solution by DSC

  22. DMA表明,改性后聚氨酯交联密度增大,具有较高的玻璃化转变温度。

    DMA showed that the modified WPU has a higher glass transition temperature .

  23. 利用差示扫描量热仪(DSC)测定TPI的玻璃化转变温度(Tg);

    And the glass transition temperature ( T_g ) of TPI was analyzed by DSC .

  24. 用动态力学方法测定玻璃化转变温度Tg研究改性树脂的相容性。

    Glass temperature T g was measured by dynamic mechanical method . The compatibility of modified resins was researched .

  25. 树脂玻璃化转变温度对GFRP拉/压性能的影响

    Effects of Resin Glass Transition Temperature on Tension / Compression Properties of GFRP

  26. 研究表明,PAN嵌段长度对PEO的熔点、PAN的玻璃化转变温度有很大的影响。

    The effect of PAN block length on the thermal properties of PEO and PAN was also study .

  27. HAN-TEAN-H2O三元体系的玻璃化转变温度的依数性和微观结构的推测

    The Colligative Property of Glass Transition Temperature and the Inference of the Microstructure for the Ternary System of HAN TEAN H_2O

  28. DSC测定蒜粉的玻璃化转变温度为-2.9℃,微胶囊化蒜粉的玻璃化转变温度为112℃。

    The glass-transition temperature of garlic powder and microencapsulated garlic powder measured by DSC were-2.9 ℃ and 112 ℃ respectly .

  29. DSC分析表明羟基丙烯酸树脂改性PUR,可稍微提高黏剂玻璃化转变温度。

    DSC showed that Tg of system can be improved slightly by hydroxy acrylic resin .

  30. 另外,PVP含量升高使CHI结晶度降低,进而使PVP/CHI凝胶的玻璃化转变温度Tg降低。

    The glass-transition temperature ( Tg ) decreases with increasing of PVP content because crystalline degree of CHI is decreased .