正力
- 网络positive force;GANEY;positive rorce;Right Power
-
扰动气压梯度力在云的中上部为负力,它抑制了云的生长发展;在云的下部为正力,它使云向上的加速度增大。
The perturbation pressure force is negative in the middle-upper parts of cloud , which suprces the growth of cloud , and is positive in the lower part which promotes the cloud upward acceleration .
-
因此,产生最大正应力的方向就是相应于主应力的方向。
Thus the directions that emerge for extremizing the normal stress are the directions corresponding to the principal stresses .
-
孔隙水压σp降低了岩体断裂面上的正应力,使原处于稳定状态的断裂发生滑移破裂。
The pore-water pressure σ p reduces the mormal stress on the fissure of rock , hence causes sliding fracture which formerly remained in stable status .
-
颗粒Reynolds正应力轨道模型及后台阶两相流动数值模拟
Particles Reynolds Stresses Trajectory Model and Numerical Simulation for a Backward-facing Step Two-phase Flow
-
在相同C下,随焊缝宽度增大,裂尖前的正应力、三轴应力(拘束)和等效蠕变应变增大,相应的损伤程度增大,蠕变裂纹起裂时间变短。
And under the same C. with increasing the weld width , the principal stress , triaxial stress and creep strain will increase , and the damage will also increase too .
-
15天至30天标本,两组间差别有显著意义(P<0.01)。并与弯曲正应力数值规律相一致。
In the 15 - day and 30 - day specimens , the difference between the two groups is significant ( P < 0.01 ), and is in agreement with the numerical rule of positive stress of bending .
-
在考虑粘结层影响的情况下给出了FRP板板端界面上剥离应力和正应力的解析表达式,分析了表达式中各物理量对界面应力的影响。
Taking the effect of adhesive layer into account , analytical formula of normal stress and shear stress at the interface are obtained and discussed .
-
在单向外载荷作用下,讨论两模型中正应力、VONMISES应力的分布规律。
The distributions of von Mises and direct stress directly leading to shear yield and interfacial debonding were discussed under uniaxial applied force .
-
以接触疲劳为基准,对因接触应力产生点蚀的接触点处的最大正应力σ(max)和最大剪应力τ(max)的计算,提供了方法。
Based on contact fatigue , a method provided is for calculating σ _ ( max ) and τ _ ( max ) at points of contact where pitting of surface is likely to emerger .
-
建立了一种LOM工艺的简化模型,通过对模型的分析,给出了零件层间正应力和切应力的计算公式。
A simplify model is proposed to describe the adhesive process and the calculation formulae of interlaminar stress are deduced by means of analyzing the model .
-
Hencky应力方程与主剪应力迹线上正应力方程的比较
The comparison between Hencky stress equation and normal stress equation along the tracing line of principal shear stress
-
借鉴预应力混凝土梁桥弯曲正应力计算方法,结合波形钢腹板PC组合箱梁桥的应力分布规律,给出了该类桥的弯曲正应力计算公式。
Borrowing ideas from the direct stress calculation of prestressed concrete beam bridge and combining the stress distributional regularity of prestressed concrete composite box-girder bridge with corrugated steel webs , this dissertation proposes the formula of bending direct stress calculation of this type of bridge .
-
合应力Sr中既包括了作用在断层面上的正应力,又包括了断层面上的剪应力,它比单独用一个应力描述应力场更有效。
The resultant stress includes not only the normal stress on the fault plane but also the shear stress on the fault plane , by which the description of stress field is more effective than by single stress .
-
这种止裂或滞后作用依赖于锯口的深度l和施于主断面上的正应力x。
The a stop-fracture effects depend on the depth of the saw kerf and average normal stress which exert on the saw cut representing the main fault .
-
宏观解理断裂应力σF是试样断裂时缺口前的最大正应力σyymax,其测定值主要由细观的σf决定,也不随加载速率、缺口尺寸和加载方式变化。
The macroscopic cleavage fracture stress F is the maximum normal stress ahead of a notch when the specimen is fractured , its measured value is determined by the local cleavage fracture stress of , and it is also independent on notch sizes , loading rate and loading methods .
-
文中引用Kelvin应力解求得了拉力型预应力锚索钢绞线侧壁、锚索孔壁剪应力τ沿轴向分布,求得了压力型预应力锚索孔壁剪应力τ及正应力σ沿轴向分布。
This paper refersed to Kelvin stress solution and gained the wall on pulling prestressed anchoring cable steel noose and shearing stress τ of the side panel , the paper also gained the shearing stress rand normal stress σ along axis of bore wall on compressing prestressed anchoring cable .
-
基于滑面正应力假设的土压力计算方法
Method for Computation of Earth Pressure Based on Normal Stress Assumption
-
钢筋桥联混凝土结构的韧带正应力计算
Calculation of the Ligament Normal Stress in Reinforced Concrete Structure
-
组合曲梁的径向应力及其对正应力的影响
Radial stress of combined curved beam and its influence on bending stress
-
智能仪表在直梁弯曲正应力实验中的应用
Application of Intelligent Instrument in Beam Bending Normal Stress Experiment
-
在计算断层面所受正应力时,仅考虑断块的垂向封闭性;
When normal stress is calculated , vertical sealability is considered only ;
-
滑面正应力分布对边坡安全系数的影响
Effect of normal stress distribution on factor of safety of a slope
-
实验表明辉长岩岩块在上述正应力下均发生粘滑现象。
Under these normal stresses in experiments on gabbro the stick-slip happened .
-
界面一点切向正应力的数值计算
Numerical method for the tangent stress at any given point of the interface
-
纤维复合材料复合型断裂正应力强度因子比准则
Normal stress intensity factor ratio criterion for mixed mode fracture of fiber composites
-
修正曲率及雷诺正应力对分离流的影响
Influence of curvature and normal stress on separating flows
-
横梁弯曲正应力计算机辅助测试系统
The CAT System of Normal Stress in Crossbeam Wind
-
圆孔蜂窝梁墩心截面正应力有限元分析与简化计算
FEA and Simplified Calculation for Normal Stresses at Mid-pier Sections of Circle-castellated Beams
-
纯弯曲正应力实验装置的改进
Improvement of Experimental Equipment of Pure Bending Normal Stress
-
实验的正应力为10&40MPa。
In experiments the normal stress were 10-10 MPa .