多孔

duō kǒng
  • porous;multihole;multiaperture
多孔多孔
多孔[duō kǒng]
  1. Li4Ti5O(12)纳米粉体及多孔薄膜电极的制备

    The preparation of Li_4Ti_5O_ ( 12 ) nanoparticle and multiaperture film electrode

  2. 多孔径径向分级调频法的白光散斑照相

    White-Light Speckle Photography of the Multiaperture Radial Grade Modulating-Frequency Method

  3. 这种奶酪多孔松脆,风味浓郁。

    This cheese has an open , crumbly texture with a strong flavour

  4. 以溶胶-凝胶法在多孔不锈钢基体上附载Al2O3膜

    Al_2O_ 3 Film Preparation on Porous Stainless Steel by Sol-Gel Method

  5. 硅基多孔β-SiC蓝光发射的稳定性

    Stability of Blue Emission from Si-Based Porous β - SiC

  6. TiO2微粒功能化多孔Al2O3膜的光电化学研究

    A Photoelectrochemical Study of Porous Alumina Membrane Functionalized with TiO_2 Particles

  7. 金属/气体共晶二维定向凝固放射状多孔Mg的结构特征

    Structural features of radial & type porous magnesium fabricated by bidirectional solidification of metal / gas eutectic

  8. 用于MEMS的选择性形成多孔硅技术的研究

    Investigation of Selectively Forming Porous Silicon Used in MEMS

  9. 用于RF无源器件的氧化多孔硅隔离层技术

    OPS insulating techniques for RF passive devices

  10. ~(129)XeNMR技术研究多孔性材料

    Investigation of Porous Materials by ~( 129 ) Xe NMR Technique

  11. 用扫描电镜(SEM)对厚度不同的多孔硅膜的微结构进行了研究。

    The typical microstructures of thick and thin porous silicon films were investigated by scanning electron microscopy ( SEM ) .

  12. V形波纹多孔体太阳能空气集热器研究

    Augmentation of convective heat transfer by means of high porosity porous insert study on V corrugated porous absorber solar air heater

  13. 另外,多孔HA在修复过程中充当了软骨下骨的临时替代。

    Meanwhile , the porous HA was the temporary substitute of subchondral bone in the period of repairing .

  14. 孔隙率对Al2O3高孔隙率多孔介质EHC的影响

    Effects of Porosity on Effective Heat Conductivity of Highly Porous Media of Al_2O_3

  15. 复合BMP的多孔金属表面植入体能够促进骨-植入体界面的骨长入。

    Porous-coated implants combined with BMP can enhance bony ingrowth at bone-implant interface .

  16. SEM分析结果表明铱钽钛金属氧化物阳极涂层呈现多孔多裂纹形貌结构。

    The SEM results indicated that all coatings were of a porous and cracked_mud microstructure influenced greatly by the composition of coatings .

  17. 以间苯二酚(Resorcinol)-甲醛(Formaldehyde)为原料,用溶胶-凝胶法和超临界干燥工艺制备了纳米多孔RF有机气凝胶。

    RF Aerogels are prepared through sol-gel process and supercritical drying technique form resorcinol with formaldehyde .

  18. 用SCLC法研究低k多孔SiO2:F薄膜的隙态密度

    Density of defect states in low-k porous SiO_2 : F film researched by SCLC method

  19. 用晶格Boltzmann方法研究多孔介质内流体的复杂动力学特征

    Lattice Boltzmann Method for Complex Fluids in Porous Media

  20. SiO2基复合多孔陶瓷载体的制备

    Preparation of sio_2 based composite porous ceramic support

  21. 用简单的气相化学反应法,在1230℃条件下,于多孔阳极Al2O3薄膜上合成出大面积高度定向的β-SiC纳米线阵列。

    Large-scale highly ordered SiC nanowires arrays were prepare in anodic alumina membranes by simple vapor-chemical - reaction approach at 123 0 ℃ .

  22. PLGA多孔支架适合作为组织工程食管支架;

    The porous PLGA scaffolds are suitable for TEE .

  23. SEM分析结果表明:碳化硅-堇青石多孔陶瓷中碳化硅颗粒排列较紧密,断面呈网格状结构;

    SEM analysis results revealed that the SiC grains in porous SiC-cordierite ceramics distributed more closely and the section surface appeared as reticular structure .

  24. TiO2纳晶多孔薄膜固态太阳电池

    Solid state tio_2 nanocrystalline solar cell

  25. 利用焓-多孔介质法对垂直Bridgman生长CdTe的数值模拟

    Numerical simulation of CdTe vertical Bridgman growth using enthalpy-porosity technique

  26. 通过分析烧结温度、Na2O含量对烧结和析晶的影响,选择了合适的烧结条件,控制烧结和析晶程度,获得了既有足够的自身强度,又有一定的结合强度的多孔玻璃陶瓷。

    By analysing the effect of sintering temperature and Na_2O content on sintering and crystallization , sintering condition for bioglass can be optimized .

  27. 多孔硅银淀积表面RhB染料分子的表面增强Raman散射

    Surface Enhanced Raman Spectroscopy of RhB Dye Molecular Adsorbed on Silver Particles Deposited on Porous Silicon

  28. 采用溶胶-凝胶法于ITO导电玻璃和石英玻璃基底上制备了均匀透明的TiO2多孔纳米薄膜。

    The uniform transparent porous nanocrystalline TiO_2 films were prepared on ITO conductive glass and quartz glass substrates by sol-gel method .

  29. 用于汽车纺织品的Dacron多孔纤维在染色工艺中的优势

    Dacron multi-channel fibers for automobile textiles-advantages in the dyeing process

  30. 利用SEM、XRD等手段分析了多孔材料的组织结构与相组成,测量、分析了不同制备工艺下空心球多孔材料的力学性能。

    By means of scanning electron microscopy ( SEM ), X-ray diffraction ( XRD ), the microstructure , phase composition and mechanical property of alloys were investigated .