圈数

quān shù
  • number of turns;cylinder number
圈数圈数
圈数[quān shù]
  1. 冲洗胶卷,并在每张照片上标明转动的圈数。

    Process the film and label each frame as to the number of turns .

  2. 变(压器)折算到一次线圈的二次阻抗次级线圈的圈数和初线线圈圈数一样。

    The number of turns of wire in the secondary coil is the same as the number of turns in the primary .

  3. C.图。平面格图的圈数

    The S. C. The Number of Cycles of Latticed Graph on Plane

  4. Hamilton图中的H圈数

    The Number of Hamilton Cycles in a Hamilton Graph

  5. 得出了一些有用的结论如平面螺旋电感的Q值随着圈数N的增加而减小;

    Experimental results are analyzed in detail and some results are obtained : quality factor Q decreasing with the increase of turns N ;

  6. 从而改善PD症状,行为检测显示毁损术后大鼠旋转圈数有所减少并接近于正常组大鼠水平。

    Thus improving PD symptoms , behavioral tests showed damage to the number of rotations of the postoperative rats decreased and close to the level of normal rats .

  7. 线圈圈数增加,Leff增加,Q值和自谐振频率SRF下降;

    The coil turns increases Leff will increase , the Q value and resonance frequency SRF will drop ;

  8. 结果1~14天时PD大鼠启动时间逐渐延长、持续时间逐渐缩短,最高转速与旋转圈数不变。

    Results From 1d to 14d the start time of PD rats elongated gradually , the continuous time shortened by degrees , the maximum rotational speed and the rotational number were invariable .

  9. 提出采用干涉的方法测量几种不同扭转圈数的扭转光纤环的Verdet系数。

    The Verdet coefficient of fiber rings with different twisted turns has been measured with an interference method .

  10. 基于旋转稳定弹丸的6D刚体弹道方程,导出了弹丸转圈数公式,可对弹丸圈数进行准确计算。

    Based on 6D rigid body trajectory equation , the spin-number formula of the projectile was deduced , by which the spin-number can be calculated .

  11. 方法通过改良PD大鼠模型,观察30只大鼠模型成功后1、7、14天旋转行为的多项指标变化,如:启动时间、持续时间、最高转速、旋转圈数等。

    Methods The markers of rotational behaviour of PD rats were observed at 1d , 7d , 14d after improved model of 30 PD rats , for example : the start time , the continuous time , maximum rotational speed , and the rotational number et al .

  12. 灌胃给药2周后用APO诱导,测试大鼠旋转行为并记录旋转开始时间、结束时间和旋转圈数。

    We induce the rats with the APO after giving the medicine two weeks , and test the rats revolving the behavior , and record to revolving to start time 、 ending time and revolving the numbers .

  13. 妈妈站在门廊数他的圈数。

    His mom 's on the porch , counting his laps .

  14. 使用了预置计数方式控制研磨圈数;

    A counter is used to exactly control the lapping circles .

  15. 长距离赛跑的终点圈数、名次记录器

    A Study of Recorder of Long Distance Running Finishing Laps and Place

  16. 平面格图的圈数

    The Number of Cycles of Latticed Graph on Plane

  17. 极小2&连通图的圈数的上界

    The Best Upper Bound for Numbers of Distinct Cycles in a Minimum 2-Connected Graph

  18. 基于弧行列式的有向图中的有向圈数

    The Number of Directed Cycles in a Directed Graph Based on the Arc Determinant

  19. 考察了磨损圈数(磨损时间)、载荷对其耐磨性的影响。

    The influence of wear time and load on the abrasion of UHMWPE was demonstrated .

  20. 圈数计在可逆式冷轧机上的应用

    Application of coil-meter on reversing cold mill

  21. 有趣的是线圈的圈数能够影响矽尖锥的结构。

    It is also interesting that the number of coils would affect the silicon-tip structures .

  22. 主要观察指标:①移植前后各组大鼠旋转圈数。

    MAIN OUTCOME MEASURES : ① rotation rounds in rats of each group after transplantation .

  23. 您可以减少您的圈数了。

    You can reduce your rounds .

  24. 针织品细度,以每1?英寸中的针圈数决定。

    The fineness of knitted cloth as determined by the number of loops per1 ? inches .

  25. 比赛一般进行8-12小时,以完成圈数的多少评定成绩。

    Competition in general for8-12 hours to complete the lap number of the number of evaluation results .

  26. 结果表明:随着悬浮线圈的圈数增多,悬浮力增大且幅度增加;

    With the increase of the loop number of levitation coil , the levitating force increases more quickly .

  27. 发现随着磨损圈数的增加其摩擦系数逐步增大,磨痕深度也不断增加。

    The results show that the frictional coefficient and the depth of wear track increase with wear revolutions increasing .

  28. 在上述参数中,自由涡圈数对计算时间的影响最大。

    The influence of time cost of these parameters was also discussed and wake length has the most influence .

  29. 结合线圈圈数、激励电流与电磁吸力之间的关系,完成了电磁系统的优化设计。

    The optimum design was realized associated with the relationship among coil turns , exciting current and electromagnetic attraction force .

  30. 从下往上计数叶子数和盘旋的圈数,直到某片叶子正好与第一片叶子在竖直方向上重合。

    counting the number of leaves and the number of turns made before returning to a leaf directly above the starting-point .