合金元素
- 名alloying element
-
合金元素Cu对过热铝熔体中氢含量的影响
Influence of the Alloying Element Cu on the Hydrogen Content in Superheated Aluminum Melt
-
合金元素Ti对D型石墨形成条件的影响
Influence of alloying element titanium on formation of D-type graphite
-
合金元素在Mg-Li基合金中的作用
Effect of Alloying Elements on Mg-Li Base Alloys
-
离子渗W,Mo手用锯条合金元素与切削性能的研究
Alloying elements in W-Mo ionized alloy hacksaw blades and their cutting performance
-
合金元素P、Cu含量对铸铁短纤维结合剂组织和性能的影响
EffEct of P and Cu Content on the Properties and Microstructure of Sintered Compacts with Short Cast Iron Fiber
-
C元素增加钢的热导率;随温度的增加,纯铁的热导率降低,同时各合金元素对热导率的影响下降。
With temperature increasing , the thermal conductivity of pure iron decreases and the influences of various alloying elements on thermal conductivity weaken .
-
探讨了SiCp/Al复合材料脉冲氩弧焊过程中合金元素Ti发生诱发反应的可行性。
The weldability of SiCp / Al composites is investigated during pulsed TIG welding through Ti induced-reaction .
-
合金元素W、B对MoSi2发热体物理化学性能的影响
Effects of B , W Elements to the Physical and Chemical Properties of MoSi_2
-
合金元素对TiC与钢润湿性的影响
Effect of Alloying Elements on Wettability between steel and TiC
-
金属间化合物FeAl与α-Al2O3的界面润湿行为及合金元素Y和Nb的作用
Wettability of Intermetallic Fe-40al / α - Al2O3 System and the Effect of Microalloys Y and Nb
-
着重分析了Mn、Ti、B合金元素对提高低温韧性的作用。
The effect of alloying elements Mn , Ti and B on the improvement of cryogenic toughness is mainly discussed .
-
对于前者合金元素M指Cr,Mo,W,Zr和Co;
Alloying element M for the former represents Cr , Mo , W , Zr and Co ;
-
合金元素Ni、Mo、W及熔渗铜对烧结钢耐磨性的影响
Influence of alloy elements Ni 、 Mo 、 W and copper infiltrated on wear resistance of sintered steels
-
合金元素对Si3N4陶瓷生成的影响
Effects of Alloy Elements on Silicon Nitride Ceramics Synthesis
-
微合金元素V抑制形变诱导铁素体相变的进行,阻碍铁素体晶粒长大,起到细化晶粒的作用。
Vanadium restrains the deformation induced ferrite transformation but hinders the grain growth of ferrite and acts as a grain refinement .
-
通过少量C与适量合金元素Mn、Si、Cr配合,制备了低碳马氏体型非调质钢。
A martensitic microalloyed steel was prepared by addition of low carbon and suitable alloying elements such as Mn , Si and Cr.
-
铬钢的耐海水腐蚀性不仅与Cr的含量有关,还与其他复合合金元素有关。
Corrosion resistance of chromium steels in seawater changes not only with chromium content , but also with other alloying elements combined with Cr.
-
研究了不同合金元素Fe、Mo、Al及添加稀土元素Nd对粉末钛合金烧结行为及力学性能的影响,并得到了烧结性能和力学性能优良的粉末钛合金。
Effects of Fe , Mo , Al , Nd elements on the sintering behavior and mechanical properties of titanium alloys were investigated .
-
合金元素Cr,Al对Sn-Ag-Cu基无铅钎料高温抗氧化和润湿性的影响
Effect of Alloying Elements Cr , Al on High-Temperature Oxidation Resistance and Wettability of Sn-Ag-Cu Based Lead-Free Solder
-
研究结果表明,润滑剂能有效地降低氧气扩散速率及合金元素如Al、Fe、V的扩散速率。
The performance of lubricant can be obviously to reduce the diffusion of oxidizing atmosphere and alloying elements , such as Al , Fe , V.
-
金属间化合物TiAl中的合金元素-结构缺陷复合体电子结构与材料物性
Electronic Structure of Alloying Element-Structure Defect Complexes and Relating Material Property for Intermetallic Compound TiAl
-
用SEM波谱分析手段,定性研究了合金元素铌在新锆合金中的存在方式。
The existing form of niobium in zirconium-based alloy containing Fe , Sn , Cr alloying elements was researched qualitatively by means of SEM .
-
研究了合金元素Cu、Mg、Zr对合金组织结构和力学性能的影响。
The effects of alloy elements Cu , Mg , Zr on construction and properties of alloys are also studied in this paper .
-
利用电子显微及X射线衍射仪分析研究了C/Cu复合材料的界面特性及合金元素铁对C/Cu复合材料界面特性的影响.研究表明复合材料界面既无化学反应也无扩散发生,C/Cu界面是物理结合。
The interface character of C / Cu composite and the influence of alloy element Fe are studied by means of electron microscopic analysis and X-ray diffractometer .
-
界面及两侧合金元素扩散的浓度呈梯度变化,尤其Al元素在焊缝中扩散的浓度梯度最显著。
The concentration of alloy elements of interface and both side of interface change by grads , especially , aluminum obviously change by grads on welding seam .
-
合金元素对Al-Li合金时效行为和力学性能的影响
Effect of alloying elements on the precipitation and tensile properties of Al-Li Alloys
-
稀土与Mg、Zn、Cu等合金元素适当组合改善润湿性的效果比单一稀土明显。
The suitable combination of rare earths and alloying elements ( Mg , Zn , Cu ) improves wettability muchmore remarkably than a single rare earth element .
-
在这些阻燃方法中,添加合金元素法对镁合金阻燃具有明显作用,富Ce稀土的添加同样对镁合金的阻燃具有显著作用。
In the methods , alloying element addition , including Ce rich RE , has the obvious effect on ignition proof of Mg alloy .
-
研究了不同加入量合金元素Cr;
This paper discusses the property of corrosion resisting high temperature strength of nickel-base sigle crystal alloys with different additive amount of alloy elements such as Cr ;
-
合金元素Mo在一定条件下与介质作用形成Fe2(MoO4)3相。
Experimental results show that the alloying element Mo reacted with corrosive medium to form Fe_2 ( MoO_4 ) _3 phase .