压汞法

  • 网络Mercury intrusion method;Mercury porosimetry;mercury injection;mip
压汞法压汞法
  1. 利用压汞法和氮吸附法测试了水泥石的孔结构,从而对干缩的微观本质进行了探索性研究。

    And pore structures of cement pastes were measured by MIP and N2 adsorption experiments .

  2. 用压汞法测量了细粒煤炭的表面分维,证实了细粒煤具有分形特征的事实,认为中国大部分矿区的煤其分维值在2~3之间;

    Surface fractal dimension of fine coal was measured by means of MIP . The fact that fine coal has fractal features was proved .

  3. 氮气吸附法和压汞法测定Al2O3载体孔结构

    Nitrogen Adsorption Method and Mercury Injection Method Determination the Pore Structure of Alumina Carrier

  4. 用压汞法和CO2吸附法对突出区煤的孔隙结构特征进行了研究。

    Abstract Porous structure characteristics of coal in outburst zone was studied by pressurized mercury method and CO2 absorption method .

  5. 应用XRD、SEM、EDS、压汞法等手段,对泡沫陶瓷的性能以及微观结构作了分析与探讨。

    The properties and microstructure of foam ceramics were analyzed and discussed by XRD , SEM , EDS , press Hg methods .

  6. 对聚乙烯(PE)隔板的微孔形态进行了研究,利用压汞法对隔板的微观结构参数进行测定,与进口样品的测试结果进行了比较。

    In this paper , the microstructure of PE separator has been studied . Mercury intrusion method has been introduced to determine the pore diameter of PE separator and its distribution .

  7. 并用XRD、压汞法测孔径、TPD、FT&IR光谱等方法对催化剂反应前后的物化性能进行了表征。

    The properties of fresh and used catalysts were characterized by methods of XRD , pore size distribution determination , TPD , FT IR spectroscopy .

  8. 这些测试方法包括:SAXS法、压汞法、氮气吸附法、有机溶剂吸附法等。

    The measuring methods include SAXS , nitrogen adsorption , mercury intrusion , organic solvent adsorption .

  9. 用氮气吸附法和压汞法测量膨胀石墨(EG)的孔结构,用SEM观察EG颗粒间的孔隙结构和EG的孔隙率。

    The pore structure of EG was measured by nitrogen adsorption and mercury porosimeter methods . The space around EG particle was observed by SEM and the porosity of EG was measured by pycnometer method .

  10. 采用共沉淀法制备了Al2O3-TiO2复合载体,采用BET法、压汞法、扫描电子显微镜、X射线衍射、吡啶吸附-程序升温脱附和吡啶吸附红外光谱法对Al2O3-TiO2复合载体进行了表征。

    Al_2O_3-TiO_2 complex support was prepared by co-precipitation and characterized by means of BET , mercury injection method , SEM , XRD , Pyridine-TPD and Pyridine-IR .

  11. 利用SEM.XRD分析了HA陶瓷的显微结构和物相,利用阿基米德法和压汞法测试其孔隙率和孔径分布,利用三点弯曲法测试其力学性能。

    Using SEM to analysis the microstructure and phase of the HA ceramics , using the Archimedes method and mercury porosimetry to test their porosity and pore size distribution , using the three point bending method to test the mechanical properties .

  12. 通过三种不同的方法(CO2吸附法、N2吸附法和压汞法)测试了不同变质程度煤的孔结构性质,分析了煤的孔结构特性与水煤浆性质之间的关系。

    Pore structure of Chinese coals with various ranks was characterized with three analytical methods ( carbon dioxide adsorption , nitrogen adsorption , mercury method ), and its effect on the properties of coal water slurry ( CWS ) was discussed .

  13. 结果表明,可逆收缩取决于水化产物的数量与C-S-H凝胶的表面性能与化学结构,随压汞法测得的小于30nm的孔体积增加而线性增加;

    The results show that the reversible drying shrinkage is dependent on the quantity , surface area and chemical structure of calcium silicate hydrate ( C-S-H ), and increases linearly with small pore volume as measured by mercury intrusion porosimetry (≤ 30 nm pore diameter ) .

  14. 运用压汞法研究低渗岩心的启动压力

    Starting pressure of low permeability cores by using mercury injection method

  15. 压汞法在固体剂型研究中的应用

    Application of mercury porosimetry in the study of solid dosage form

  16. 基于恒速压汞法的低渗透储层分形研究

    Fractal study of low permeability reservoir based on constant-rate mercury injection

  17. 压汞法测量玻璃毛细孔中的水和正癸烷

    Mercury porosimetry for the determination of water and n-decan in porous glass

  18. 压汞法计算模型的理论修正

    A theoretical modification of the calculation model for mercury porosimetry

  19. 压汞法测定材料孔结构的误差分析

    Analysis of Error for Pore Structure of Porous Materials Measured by MIP

  20. 核磁共振与压汞法的孔隙结构一致性研究

    Consistency of pore structures between NMR and mercury intrusion method

  21. 应用麻皮效应对压汞法毛管压力曲线的修正使用方法

    Using Pockmarks - effect to Modify the Capillary Pressur Curves

  22. 并用压汞法对蚕丝的大孔孔穴结构进行了补充。

    And mercury intrusion method is a complement for macroporous structure of silk .

  23. 用压汞法测定了拉伸丝的微孔含量。

    The micropore content was measured by mercury porosimeter .

  24. 压汞法分析C/C复合材料平板的孔隙结构

    Investigation of Pore Structures of C / C Composite Plates by Mercury Intrusion Method

  25. 压汞法测定储层岩石毛管压力曲线存在麻皮效应。

    There exists pockmarks - effect during the PC - Curve determination by mercury injection method .

  26. 氮气吸附法和压汞法在测试泥页岩孔径分布中的对比

    Contrast of nitrogen adsorption method and mercury porosimetry method in analysis of shale 's pore size distribution

  27. 本文采用压汞法研究大孔共聚物的孔隙结构组成及其测定方法。

    This paper describes the composition of pore structure of copolymers and their determination by mercury porosimeter method .

  28. 本文介绍用压汞法测定大孔树脂孔参数的简单原理和测定方法。

    This paper introduces the application of simple principle of porosimeter method to the determination of pore parameters .

  29. 通过压汞法研究了拉伸工艺对微孔膜孔隙率和孔径分布的影响。

    The effects of stretching process on the membrane 's porosity and pore size distribution were researched through mercury porosimetry .

  30. 采用压汞法对大同和屯留煤样进行微结构测试。

    Micro-structure of coal samples from Datong coal mine and Tunliu coal mine were respectively detected using mercury intrusion method .