饱和磁化强度

  • 网络m s;saturation magnetization;saturated magnetization;magnetization
饱和磁化强度饱和磁化强度
  1. 以Sal-LCH纳米棒为前体,在不同的气氛中焙烧得到四氧化三钴纳米棒和高饱和磁化强度的钴纳米棒。

    The cobalt oxide nanorods and cobalt nanorods which have a high saturation magnetization were obtained by calcining Sal-LCH nanorods precursor in different conditions .

  2. 高饱和磁化强度体状Fe(16)N2化合物

    Investigation of High Saturation Magnetization of Bulk Fe_ ( 16 ) N_2 Compound

  3. 高饱和磁化强度α〃-Fe(16)N2的研究

    Study on α″ - Fe_16N_2 with High Saturation Magnetization

  4. 样品的饱和磁化强度和矫顽力随Ni含量的增加呈下降趋势。

    The saturate magnetization and coercivity decrease as Ni content increases .

  5. 采用机械合金化的方法制备出Mn70Bi30纳米晶粉末。通过X射线衍射和饱和磁化强度的测量,研究了球磨过程中样品的结构和磁性的变化。

    Nanocrystalline Mn 70 Bi 30 powders have been synthesized by mechanical alloying process .

  6. 纳米金属Ni的饱和磁化强度和居里温度的尺寸依赖效应

    Size-dependent saturation magnetization and Curie temperature of nanocrystalline nickel

  7. 表面效应对γ-Fe2O3微粉饱和磁化强度的影响

    Surface effects on saturation magnetization of fine γ - fe_2o_3 particles

  8. 研究了比饱和磁化强度随Fe层厚度的变化规律并探讨了它的机理。

    The dependence of specific saturation magnetization on thickness of Fe layer has also been discussed .

  9. 磁粉粒度分布均匀,比饱和磁化强度Ms较高。

    The size distribution of magnetic nanoparticles is uniformity and the saturation magnetization is high . b.

  10. 饱和磁化强度Ms及其测量

    Saturation magnetization and its measurement

  11. Ti(CN)基金属陶瓷饱和磁化强度和矫顽磁力的研究

    Study of saturation magnetization and coercive force of Ti ( CN ) base cermets

  12. 烧结气氛对Ti(CN)基金属陶瓷饱和磁化强度的影响

    Influence of Sintering Atmosphere on the Saturation Intensity of the Ti ( CN ) Base Ceramets

  13. Dy2AlFe(16-x)Mnx化合物的饱和磁化强度和居里温度

    Saturation magnetization and curie temperature of Dy_2AlFe_ ( 16-x ) Mn_x compounds

  14. 磁性研究表明,与块体金属Ni相比,纳米胶囊的饱和磁化强度减小,而矫顽力增加。

    Magnetism research shows that the saturation magnetization of nanocapsules decreases and the coercive force of nanocapsules increases , compared with pure bulk Ni .

  15. 高饱和磁化强度ε-Fe3N磁性液体的研制

    Preparation of High Saturation Magnetization ε - Fe_3N Magnetic Fluid

  16. 研究表明,随着腐蚀程度的加深,内部空心度增加,Fe含量减小,引起了饱和磁化强度的降低。

    Results showed that the internal cavity increased as the corrosion time increased , and the saturation magnetization decreased due to the decrease of Fe content .

  17. Fe(83)Nb6B(11)合金的饱和磁化强度和有效各向异性

    Temperature dependence of saturation magnetization and effective magnetic anisotropy of fe_ ( 83 ) nb_6b_ ( 11 ) alloy

  18. 研究结果表明:Co/Pt多层膜中单位体积Co的饱和磁化强度MsCo小于块状Co的饱和磁化强度;

    The results showed that the saturation magnetization of per unit volume Co in Co / Pt MLs , Ms Co , was smaller than that of bulk Co .

  19. 以Fe膜及Fe-N薄膜为具体研究对象,采用直流磁控溅射法制备了具有高饱和磁化强度的Fe-N薄膜。

    The Fe-N thin films with high saturation magnetization were prepared by DC magnetron sputtering .

  20. 铁纤维长径比增加会使单位面积饱和磁化强度(Ms)增大、矫顽力(Hc)减小。

    The saturation magnetization per m ~ 2 of the iron fibers increased with the increasing of the length / diameter ratio , but the coercive field decreased .

  21. 结果不同制备条件影响着DMN有效粒径和比饱和磁化强度的大小。

    Results Different preparation conditions could influence the effective diameter and Ms of DMN .

  22. 非磁性替代原子对Ce2Co(17)居里温度和饱和磁化强度的影响

    Influence of Non-Magnetic Substitution Atoms on Curie Temperature and Spontaneous Magnetisation of Ce_2Co_ ( 17 ) Compounds

  23. 实验结果表明,二段连续退火与一次退火相比较,合金的矫顽力Hc显著降低,饱和磁化强度略有提高;

    Experimental results show that the coercivity of two-stage annealed samples decreases obviously and saturation magnetization increases slightly , compared to that of one-stage annealed sample ;

  24. 通过化学镀方法获得纳米晶Co-B合金,分别研究了沉积层厚度和热处理温度对其矫顽力和比饱和磁化强度的影响。

    The Co - B alloy with nanocrystalline grains was produced by electroless plating .

  25. MGM中Fe3O4含量为6.17%时,比饱和磁化强度σs达6.5emu/g;

    The saturated magnetization of MGM reached 6.5 emu / g while the Fe_3O_4 content were 6.17 % .

  26. 而经1000℃退火处理6h后,加场和不加场得到的粒子饱和磁化强度均大幅提高。

    After annealing treatment at1000 ℃ for6h , the saturation magnetizations of particles have been greatly increased with magnetic field or not . 2 .

  27. 对于FexTi100-x非晶合金粉末,随Fe含量的增大,样品的饱和磁化强度增大,矫顽力减小,当Fe含量为30at%时无论饱和磁化强度还是矫顽力都与此变化规律发生了偏离;

    For the amorphous alloy powders , the saturation magnetization increased and the coercivity decrease with the content of Fe increasing , but both the situations made a change when the content of Fe was 30at % ;

  28. 纳米Fe颗粒的比饱和磁化强度Ms和Curie温度Tc随颗粒尺寸减小而降低.探讨分析了Fe-In2O3颗粒膜中纳米Fe颗粒的Ms和Tc随颗粒尺寸变化的原因。

    The specific saturation magnetization ( Ms ) and Curie temperature ( Tc ) of the nanometer-sized Fe particles decrease with the decrease of particle dimension , and the causes are explored and analyzed .

  29. 通过用Cu或Ag部分替代Sr和少量Sr空位,使样品的居里温度和比饱和磁化强度比替代前的La(0.67)Sr(0.33)MnO3材料显著降低,而起始磁化率反而增加。

    The Curie 's temperature Tc and saturation magnetization decreased obviously by Sr substituted with Cu or Ag and Sr2 + vacancy in the samples , while the initial susceptibility is increased .

  30. WC-Co合金的4πσ同抗弯强度间并不存在明确的对应关系,因而难以用饱和磁化强度(Ms或4πσ)取代σ(TRS)的测定。

    There is no definite relationship of 4 πσ vs. σ( TRS ) of WC-Co alloy , so the σ( TRS ) measurement can hard be replaced by Ms or 4 πσ .