热功率

核电站核蒸汽供应系统的热工设计裕度中有一部分如4%可用于增加堆芯热功率和汽轮机出力。

In the thermodynamic design surplus in the nuclear steam supply system of the nuclear power station a small part ( like 4 % ) can be used to increase the thermal power of the reactor core and turbine output .

本文还给出了一种以Cu电阻加热的温控模型，提供了一种精确热功率输出控制的结构方案。

This paper also showed us a temperature control model with Cu resistance heating and provided a precise control structure plan of thermal power output .

TIG焊有效热功率控制新方法

A New method of TIG Welding With the Effective Heat Power Controlled

本文综述了人工神经元网络（ANN）在核电工程中的应用现状，包括：报警处理和故障诊断，热功率预测，传感信号的有效性确认；

This paper presents a survey of applications of Artificial Neural Network ( ANN ) to the nuclear power engineering .

研究了EPDM／LLDPE／CB复合型导电高分子材料电阻率的温度依赖性，炭黑含量的依赖性及热功率特性。

The dependence of resistivity on temperature and carbon black content , and power characteristics of EPDM / LLDPE / CB conductive polymer composite were studied .

通过响应矩阵算出堆外探测器各节电流及堆外核仪表系统（RPN）刻度系数，进而得到堆芯热功率水平（Pr）及堆芯轴向功率偏差（DI）。

By means of which , the currents of each section of the chamber and the calibration coefficient are calculated . Therefore the theory in-core thermal power level Pr and axial offset DI are obtained .

为实现厚壁紫铜的常温焊接，分别对氩-氦和氩-氮混合气体TIG电弧进行了静特性和热功率测定，并在此基础上进行了焊接对比试验。

In order to bring the welding of thick wall red copper to success at room temperature , measurements have been made for static performance and thermal power of TIG welding with protected gas mixture of Ar-He and Ar-N2 respectively .

本文建立了LFW焊机振动系统的简化模型，分析推导了LFW过程中摩擦界面不同部位摩擦产热功率的变化关系；

In this paper , a simplified model for LFW vibration system was established and the frictional heat flux at different regions of the interface was analyzed .

目的探讨激光间质热疗（LITT）治疗胶质瘤的最适热功率、照射时间、热效应及作用机制。

Objective To explore the optimal heating power , heating time , effects and mechanisms of laser interstitial thermotherapy ( LITT ) for treatment of glioma .

性能测试表明：钚量热计的样品热功率测量下限为4mW、测量上限高于9W，灵敏度约为202mV·W~（-1），线性范围为4mW～9W。

The performance tests show that the sensitivity of calorimeter is about 202 mV · W-1 and the linear scope of the measuring thermal power is from 4 mW to 9 W. The thermal power of plutonium was measured by the calorimeter .

反应堆堆芯热功率测量方法及其误差分析

A Measurement Method Regarding Reactor Core Thermal Power and Error Analysis

开关稳压电源的热功率与散热

Heat Power and Heat Elimination of Switching Stabilized Voltage Supply

渐开线圆柱齿轮减速器的热功率计算

Thermal capacities calculation of the involute cylindrical gear reducer

在计算温度场和流量场的同时也得到了传热系数和线性热功率的分布。

The results describe the thermal power distribution and the heat transfer coefficient .

用热功率自动校准的核功率表

New Nuclear Power Instrument Automatically Calibrated by Thermal Power

四环板式针摆行星传动减速器的热功率分析

Thermal Energy Analysis of Double Crack Four Ring-Plate Cycloid

核电站热功率跟踪汽轮机负荷的动态矩阵控制仿真研究

Simulation study of dynamic matrix control of the nuclear reactor thermal power tracking system

重水慢化水冷反应堆核能－－轻水堆核燃料衰变热功率的计算

Nuclear energy-Light water reactors ? Calculation of the decay heat power in nuclear fuels

在进行沸腾浸取时，随着加热热功率的增大，姜辣素的提取速率也在加快。

The extracting rate of " boiling extraction " becomes greater with increasing heat flux .

提高热功率有利于提高齿轮减速器的工作效率，减少能源的浪费。

Raising Heat power will benefit working efficiency , and reduce the waste of energy sources .

采用温升法测量了电弧的热功率和静特性。

Elevated temperature method is used to measure the thermal power and electrical properties of welding arc .

抽油泵摩擦磨损试验机的热功率和热平衡分析

Analysis of the heat power and the heat balance in the friction-and-attrition test machine of the oil suction pump

反应堆热功率输出为4250MW，平均线功率密度为179.5W/cm。

The reactor thermal output is 4 250 MW , and average linear power density is 179.5 W / cm .

介绍了行走减速器热功率分析的方法，并与试验结果进行了分析对比。

The analyse method of heat-power on crawler gear-reducer was told , and compared the calculate result with the experiment result .

蒸汽容积与热功率之间正比关系的比例系数是蒸汽容积与压力反比关系比例系数的两倍。

The proportional factor of the steam volume and thermal power is two times than that of steam volume and pressure .

介绍了无油超高真空系统、控制系统、烘箱与热功率以及软件的设计。

Oil free high vacuum system , control system , heat system , it 's power and the control program have been introduced .

当样品热功率不小于160mW时，精密度好于0.22%（1σ）。

The measuring accuracy of the calorimeter is better than 0.22 % ( 1 σ) when specimen thermal power is not less than 160 mW .

在纯氩气氛中，垂降外特性和双曲线外特性两种电源，都不能在弧长波动时保持工件有效热功率不变。

Only when the arc is intensely constricted by the mixed gas , the power source with hyperbolic external characteristics would then be slightly better .

移动床全尺寸连续燃烧实验表明，这种操作方式的优点为床内装量小，热功率释放平稳，易于控制。

The experimental results also show that the moving-bed operation is better than batch operation in lower hold-up , more stable thermal power and easier control .

结果表明：方波和正弦波调幅磁场的感应热功率都与调幅波频率无关。

The results show that the induction heat power of magnetic field amplitude-modulated with sine wave and square wave is unrelated to the frequency of modulating wave .