样机试验

  • 网络Prototype testing
样机试验样机试验
  1. 最后给出了限流器样机试验的调试和实验波形。证明了限流器的限流效果。

    Finally , the current limit for prototype testing and commissioning of the waveform are given to justify the effect on limiting the short-current of the new solid-state current limiter .

  2. 论文主要从牵引变流器的工程化实践出发,通过样机试验和仿真相结合的方式,设计出具有完全自主知识产权的大功率机车牵引变流器,并为今后其它变流器的设计与开发提供参考。

    From practical engineering of traction converter , high-power locomotive traction converter with completely independent intellectual property has been designed through prototype testing and simulation , offering reference for other converter in future .

  3. 所以,基于Extend软件的动态仿真是可行的,同时所建立的动态仿真模型也为进一步研究起落架的样机试验奠定了基础。

    So the dynamic simulation based on Extend software is feasible . And the simulation model set some foundation for further studying landing gear 's test .

  4. 样机试验结果表明,此智能控制系统能显著改善CO2焊机性能,降低焊接飞溅。

    The testing results show that the developed self optimizing control system obviously improve the performance of CO 2 welding machine and reduce welding spatter .

  5. 该方法对系统的计算单元要求很低,图像刷新率快,便于DSP实现,已经在样机试验中取得了良好的效果。

    This method need less requirement for the calculation units , the refresh of the image is very fast , and easy for the implement of the DSP , it has taken well effect in test of the sample machine .

  6. 新产品的样机试验是产品设计过程中不可逾越的关键环节,但物理样机(PhysicalPrototyping)的制作及试验是严重影响产品设计与制造周期和成本的关键问题之一。

    The experimentation of prototype of new product is a key process not to overstep in product design cycle . But the fabrication and test of physical prototyping is one of the key problems that gravely affect cycle and cost of product design and manufacture .

  7. 通过样机试验证明该逆变器符合光伏并网的相关要求。

    Testing show that the photovoltaic inverter meeting the relevant requirements .

  8. 仿真分析与样机试验得到预期效果。

    Simulation analysis and the result of real experiment proved the scheme .

  9. 复合式油气水分离器研究进展之二&分离器样机试验陕北石油秩序

    Progress report 2 of the combined oil-gas-water separator & Separator prototype test

  10. 探头式电磁流量计的理论研究和样机试验

    Theoretical study and model experiments of probe-type electromagnetic flowmeter

  11. 样机试验表明,轮履复合式移动系统能较好地应用于特殊工作环境的探测车。

    Further the new moving system can be better applied to the special tasks .

  12. 能自起动的抽水蓄能电站用双速同步发电电动机,第二部分模拟样机试验研究

    A Self-Starting Two-Speed Synchronous Generator-Motors for Pumped-Storage Power Station , Pt . ⅱ - Experiment

  13. 经样机试验证明,结构设计合理,效果良好。

    After prototypical experiment , the structural design is reasonable , the effect is good .

  14. 样机试验与性能仿真分析表明,此种设计方法是可行的。

    Model designing and performance simulating demonstrates that this new designing method is very feasible .

  15. 样机试验合格后,发给合格证书。

    A certificate of quality shall be issued after the test of prototype is passed .

  16. 应用实例设计及虚拟样机试验。

    Application design and virtual prototype test .

  17. 通过联机调试分析,获得了样机试验数据和相关波形。

    Experimental data and related waveforms of model machine are achieved through debugging on-line and analysis .

  18. 风速场的模拟结果与样机试验测量的结果基本一致,符合实际规律。

    Wind field simulation results and actual test measurement results , in line with the actual law .

  19. 通过样机试验证明,介绍的电磁设计方法合理,具有参考价值。

    The prototype experiment shows that the electromagnet design is reasonable and practicable , with reference value .

  20. 阐述了关键部件的设计要点,并进行了样机试验数据分析。

    In addition , design gist of its key components is elaborated and experimental data analysis is conducted too .

  21. 通过理论分析和样机试验证明了绕组换接的有效性。

    The validity of the winding switch operation of the BDCM is verified through theoretical analysis and prototype experiment .

  22. 样机试验结果表明所研制的数字直接点火系的方案可行、性能可靠。

    The experimental results indicate that the DDI system is reliable and feasible for the studied IC engine prototype .

  23. 在样机试验的基础上,对其主要工作性能作了论证;

    And the main performance in operation of the machine is demonstrated on the base of the experiment on its prototype .

  24. 通过样机试验,证明了这种设计方法不仅可以提高井泵的单级扬程,还可以提高水泵效率,实现深井离心泵全扬程无过载运行。

    By using CFD and model tests , it is confirmed that this approach can increase both pump head and efficiency .

  25. 样机试验证明该系统能够实现混合动力汽车所要求的各项功能,而且制造成本低廉。

    The prototype test shows that the system can meet all functional requirements of hybrid electric vehicles with low manufacturing cost .

  26. 对改进前后的机架进行了物理样机试验,验证了分析结果的可靠性。

    Verify the reliability of the analysis result by acting the physical test on the frame of the cutter before and after improved .

  27. 最后,通过样机试验充分验证了多绕组磁通控制可调电抗器其具有的以往的可调电抗器无以伦比的优点;

    Last , the experimentation on the prototype proves that the multiple windings magnetic flux controlling adjustable reactor is more excellence than ever .

  28. 经样机试验表明,采用涡流电导率原理的烧伤检测仪具有操作简单、检测结果准确可靠的特点,完全可取代传统的烧伤检测方法。

    Practical running shows that new burn inspector can replace traditional method of burn inspection completely because of its simple operation and high dependability .

  29. 最后通过样机试验,对仪器的有效性进行了验证,表明该方案合理可行,设计可靠。

    Finally , the prototype test , the validity of the instrument is verified , that the program is reasonably practicable and reliable design .

  30. 样机试验表明,该充电器具有自动调整控制结构参数及故障自诊断等良好性能,便于现场应用。

    Exprimental results show that the charger is able to auto-adjust control structure parameters , and can diagnose self-fault and use easyly in the field .