摩擦条件

摩擦条件对Al2O3/Cu复合镀层耐磨性的影响

Effect of Friction Condition on Wearing Resistance of Al_2O_3 / Cu Composite Coating

采用三种不同材料的斜槽、法拉第筒和数字电荷仪，研究了三种粉状RDX在摩擦条件下产生的静电带电量。

The quantity of static electricity of three kinds of powder RDX , produced in the friction condition is tested by adopting three groups of instruments with different materials : flume , faraday canister and digital charge meter .

干摩擦条件下3Y-TZP/（Mg，Y）-PSZ陶瓷摩擦副的磨损性能的研究

Wear Properties of 3Y-TZP / ( Mg , Y ) - PSZ Ceramic Pair under Dry Conditions

快速凝固Al-Si合金干摩擦条件下的磨损特性

Wear Characteristics of a Rapidly Solidified Al-Si Alloy under Dry Sliding

分别在三元复合驱水溶液润滑及干摩擦条件下对不同Al2O3/TiO2配比的陶瓷进行了摩擦性能测试。

The friction property of Al_2O_3-TiO_2 ceramics with various component ratios was tested under ASP solution lubrication and dry sliding respectively .

基于Bézier曲面造型的触模和摩擦条件施加算法

Algorithm of Touching Mould and the Application of Boundary Friction Based on the Formation of B é zier Surface

干摩擦条件下Al2O（3f）／ZL109复合材料的磨损行为

Wear Behaviour of Al_2O_ ( 3f ) / ZL109 Composite under Dry Sliding Conditions

在干摩擦条件下，镀层中的SiC粒子体积分数在5.8%时复合镀层耐磨性最好；

Under the condition of dry sliding , Ni-SiC composite coating with 5.8 % volume fraction of SiC particles get the most excellent wear resistance .

探讨了填料组成对复合材料硬度和干摩擦条件下摩擦磨损性能的影响，并研究了PTFE基复合材料磨损表面的形貌学。

The effects of the compositions of the filler on the hardness and tribological properties of the composites under dry condition were studied .

干摩擦条件下MoSi2/45钢摩擦磨损性能的研究

Dry friction and wear properties of intermetallics MoSi_2 against 45 steel

干摩擦条件下，MoS2/SiC复合涂层不同程度降低钢基体的摩擦系数，磨损机制呈现粘着磨损和磨粒磨损综合作用。

MoS_2 / SiC composite coatings declined the friction coefficient under the dry condition , and produced the adherence wear and abrasive wear .

高速摩擦条件下，Fe能促进摩擦面氧化膜的形成，减小材料的摩擦系数和磨损量。

At the same time , at high speed friction , Fe takes part in formation of oxide film on friction surface , so the wear loss of friction material is decreased .

MoSi2/45~钢在干摩擦条件下的滑动摩擦磨损性能

Dry Sliding Friction and Wear Characteristics of MoSi_2 against 45 Quenched and Tempered Steel

干摩擦条件下WC增强Cu-Mn-Ni复合涂层的磨损性能研究

Study on Wear Resistance of WC / Cu-Mn-Ni Brazing Coating Under Dry Sliding

TiN/TaN多层膜以球-盘方式同GCr15钢在干摩擦条件下配副时的主要磨损机理为犁削、粘着和局部剥落。

The wear mechanism mainly consists of ploughing , adhesion and local spalling .

在一定的摩擦条件下，完成ECAP所需的变形抗力与材料流动应力成线性关系；

The load needed for ECAP divided by the punch cross section is linearity relation with material flow stress with determinate friction factor ;

并借助SEM和XPS对该摩擦条件的磨损失效机理进行了研究。得出了高速非润滑条件下磨损率与氧化膜的类型和剥落之间的关系。

The mechanism of failure in wear under that condition are analyzed with SEM and XPS , finding out the relation between wear rate and types of oxide film as well as its pelling off .

摩擦条件对高强铝合金单次ECAP作用的有限元模拟

Finite Element Simulation of the Effects of Friction on the Equal Channel Angular Pressing ( ECAP ) of Single Pass for High-strength Aluminum Alloy

研究了不同玻璃纤维表面处理对PTFE复合材料在干摩擦条件下滑动磨损性能的影响，并借助扫描电子显微镜（SEM）分析了磨损机理。

The effects of different surface treatments of glass fiber on the sliding wear behaviors of PTFE composites were investigated under dry friction conditions . The worn surfaces were analyzed using a scanning electron microscope ( SEM ) .

合金化研究表明，添加一定量的Ti和Mo可改善高温摩擦条件下反应烧结SiC的干摩擦性能。尤其是在600℃时添加Ti的反应烧结SiC表现出了良好的自润滑特性。

In the end , one can find that the addition of titanium and molybdenum elements would be improved the dry tribological properties of RB-SiC under the elevated temperature , and the reaction-bonded silicon carbide with titanium behaves good self-lubricating properties at 600 ℃ especially .

在干摩擦条件下利用SRV磨损试验机比较了在硬质合金基体上金刚石薄膜、石墨/金刚石复合膜以及硬质合金3种试样的摩擦学性能。

The tribological properties of diamond films , graphite / diamond composite films and cemented carbides were compared using a SRV wear testing machine with dry friction .

研究了稀土元素处理玻璃纤维填充金属塑料多层复合材料在冲击载荷、干摩擦条件下的摩擦和磨损性能，并利用扫描电子显微镜（SEM）对磨损表面进行了观察和分析。

The friction and wear properties of metal plastic multilayer composites were investigated under impact load and dry friction conditions . The composites were filled with glass fiber with or without rare earth treatment . The worn surfaces were observed and analyzed by scanning electron microscopy ( SEM ) .

在干摩擦条件下，纯PTFE板料主要发生粘着磨损和微凸体刨切，3层复合材料主要是磨粒磨损，钉板型复合材料的磨损机理是粘着磨损和磨粒磨损共同作用。

Under dry friction condition , the wear mechanism of pure PTFE material was adhension wear and ting convex grain planning , the wear mechanism of three-layer composite was abrasion , the wear mechanism of copper nail plate composite was conjunct effect of adhesion and abrasion .

在干摩擦条件下，对不同碳纤维含量的碳纤维／中铜石墨复合材料，进行了50h的摩擦磨损试验，并借助扫描电镜观察了它们的磨面。

In this paper , the friction and wear fests of carbon fiber / medium copper graphite composites with different carbon fiber contents were conducted for fifty hours under dry friction condition , and their worn surfaces were observed by SEM .

分析了Ni-Fe-W合金镀层在干摩擦条件下摩擦因数随载荷以及速度的变化情况，并与Ni-W合金镀层以及硬铬镀层进行了比较，探讨了干摩擦条件下Ni-Fe-W合金镀层的摩擦磨损机制。

The relationship among the friction coefficient , load and velocity under dry frictional condition was derived , the wear resistance was compared among chromium coating , Ni-W alloy coatings and Ni-Fe-W alloy coatings respectively , and the frictional and wear mechanism of Ni-Fe-W alloy coatings was analyzed .

干摩擦条件下丁腈橡胶磨损金属的机理

Machanisms of Wear of Metal by Rubber under Dry Friction Condition

自润滑抗磨浸银石墨及其在干摩擦条件下的应用

Application of Self-Lubricating and Anti-Wear Silver Impregnated Graphite under Dry Friction

干摩擦条件下天然橡胶/钢的磨损机理研究

Wear Mechanisms of AISI 1020 Steel against Natural Rubber under Dry Sliding

二硅化钼自配副在干摩擦条件下的摩擦学性能研究

Friction and Wear Behavior of Molybdenum Disilicide Self-matched Pair under Dry Friction

高速干摩擦条件下铝基复合材料的摩擦磨损行为研究

Friction and Wear Behavior of the Materials under Very High Sliding Velocity