微动磨损

环境气氛对钛合金微动磨损特性的影响

Environmental atmosphere effect on Fretting Wear Characteristics of titanium alloy

采用不同类型焊条进行堆焊获得的堆焊层金属具有不同的微动磨损特性。

The deposited metals obtained by surfacing process using electrode of different types have differential fretting wear characteristics .

电刷镀Cu／Ni纳米多层膜的微动磨损性能

Micro-motion wear resistance of electro-brush plated Cu / Ni nano-multilayer film

电刷镀镍/镍包纳米Al2O3颗粒复合镀层微动磨损性能研究

Anti-fretting Properties of Ni / Ni-coated nano-Al_2O_3 Composite Coating Prepared by Electro-brush Plating

W离子注入奥氏体不锈钢的微动磨损性能

Investigation on the Fretting Wear of W-Implanted Stainless Steel

Ni-P-纳米Al2O3复合镀层的抗微动磨损性能

Fretting Wear Resistance of Ni-P-nanoAl_2O_3 Composite Coating

油溶性纳米Cu在微动磨损条件下的自修复行为与机理研究

Study of Self-repair Property and Mechanism of Nano Cu as Lubricating Oil Additives under Oscillating Friction and Wear

TiC/Ti（C，N）/TiN复合涂层在滑移区的高温微动磨损特性

Fretting Wear Behaviour of TiC / Ti ( C , N ) / TiN Multi-Layer Coatings at Elevated Temperature in Gross Slip Regime

爆炸喷涂Cr3C2/25NiCr涂层抗微动磨损性能的研究

The study of fretting wear resistance of detonation gun spraying Cr_3C_2 / 25NiCr coating

制备工艺对MoS2粘结固体润滑涂层微动磨损寿命的影响

The Influence of Preparation Processes on Fretting Wear Life of MoS_2 Bonded Solid Lubricating Coating

纳米SiO2颗粒增强镍基复合镀层的组织与微动磨损性能研究

Microstructure and Fretting Wear Behavior of Ni based Composite Coatings Reinforced by SiO_2 Nanoparticles

D2钢电子束表面改性抗微动磨损性能研究

High Current Pulsed Electron beam Modification on Fretting Wear Behavior of D2 Die Steel

湿度、温度及润滑油对粘结MoS2固体润滑涂层微动磨损寿命的影响

Influence of Relative Humidity , Temperature , Oil Lubrication on the Fretting Wear Life of Bonded Solid Lubricant Coating

两种Fe-C合金的转动微动磨损研究

Research on Rotational Fretting Wear of Two Fe-C Alloy

Cr-Mo合金电镀层抗微动磨损特性的研究

Study on the Fretting Wear-Resistance Behaviors of Cr-Mo Alloy Coatings

等离子喷涂CoCrW、Cr3C2/NiCr和WC/Co涂层的微动磨损行为

The behavior of fretting wear of plasma sprayed cocrw 、 cr_3c_2 / nicr and wc / co coatings

油、水介质对GCr15钢微动磨损特性的影响

Influence of Oil and Water Mediums on Characteristics of Fretting Wear of 52100 Steel

研究了K417镍基高温合金的微动磨损行为。

Fretting wear behavior of K417 nickel base superalloy was investigated .

PEEK树脂具有突出的摩擦学特性，耐滑动磨损和微动磨损性能优异，尤其是能在250℃下保持高的耐磨性和低的摩擦系数；

PEEK resin has a prominent tribological properties , sliding wear resistance and excellent wear budge , especially in250 ℃ can maintain the wear resistance of high and low friction coefficient ;

采用球-平面接触微动磨损试验机考察了轧制固溶316L不锈钢在不同极化状态下的微动磨蚀行为。

The influence of applied potential on the fretting corrosion wear behavior of 316L stainless steel in saline solution has been investigated with a test rig of ball on plane contact configuration .

I-800合金高温微动磨损特性研究

Fretting Wear Behavior of Alloy-800 at High Temperature

在微动磨损条件下，随着掺杂ZrC数量的增加，合成产物的主要磨损机制由粘着磨损、剥层磨损、氧化磨损和磨粒磨损逐渐转化为以剥层磨损和粘着磨损为主。

On the condition of SRV wear , The predomination wear mechanisms of the products translate gradually from oxidation and abrasive wears to adhesion and desquamate with the increase of doped ZrC content .

用弹性圈柱销联轴器测定HB-21型干膜润滑剂的微动磨损速率

The fretting rate of a dry film lubricant ( hb-21 ) is determined by means of the rubber buffer coupling

以UHMWPE球为对磨偶件，分别在4种法向载荷下（40N、60N、80N和100N），在大气及润滑环境里对阳极氧化试样进行微动磨损实验。

The fretting wear tests of the anodized specimens against UHMWPE ball were carried out under four kinds of normal load ( 40N , 60N , 80N , 100N ) respectively in air atmosphere and lubrication conditions .

人股骨密质骨横断面的微动磨损特性研究

Fretting Behavior of the Cross Section of Human Femur Cortical Bone

构件微动磨损疲劳&盘上周向燕尾榫槽的特点分析

Fretting fatigue in component & the feature in circumferential dovetail joints

两种合金高温微动磨损性能研究

Studies on the High Temperature Fretting Wear Behavior of Two Alloys

滚动轴承微动磨损导致的振动分析

Analysis on Vibration Caused by Micro-Motion Wear for Rolling Bearings

一种测定润滑脂抗微动磨损性能的方法

A Method of Determining Fretting Protection Properties of Lubricating Greases

化学镍磷镀层微动磨损力学分析及应用

Mechanical Analysis of Fretting Wear of Ni-P Electroless Coating and Its Application