墙面抹灰

  • 网络Wall plaster
墙面抹灰墙面抹灰
  1. 浅议加气混凝土砌块墙面抹灰质量通病的防治

    Discussion on Prevention and Treatment of Common Quality Problems of Autoclaved Aerated Concrete Block Wall Plaster

  2. 填充墙砌筑完成后60d左右进行墙面抹灰和构造柱施工;

    The mortar for coating and configuration column should carry through when the infilled wall was masonry sixty days .

  3. 冬期内外墙面抹灰冷作施工

    Cold-process construction for external and internal wall plastering in winter

  4. 墙面抹灰层中加挂钢网的防裂漏及防剥落问题

    The prevention for leaking and flaking in floated coat with steel mesh

  5. 关于墙面抹灰层空鼓龟裂的分析与建议

    Analysis on the cracks of floated coat on wall surface

  6. 加气混凝土砌块墙面抹灰空鼓与裂缝的分析及预防

    Analysis and prevention of hollowing and crack in plastered wall of aerated concrete block

  7. 加气混凝土墙面抹灰裂缝原因分析及防治

    Analysis on cause of split on wall of concrete with gas and its prevention

  8. 关于墙面抹灰质量问题的分析与防治

    Analysis on wall plastering and its prevention

  9. 文章分析了加气砌体墙面抹灰裂缝出现的原因并提出了一系列控制裂缝的措施。

    This paper analyzes the causation of filling cracks in aerated concrete block and puts forward a series of control measures .

  10. 针对加气混凝土墙面抹灰的裂缝问题,从结构、材料两方面就裂缝产生的原因进行了分析,并提出了相应的防治措施,在施工中运用,可以达到良好效果。

    Aim at to add to annoy the concrete wall to face the crack problem of put on the ash , carried on the analysis for the output reason from the structure , the material both side , and put forward the homologous prevention and cure measure .

  11. 聚丙烯纤维在墙面水泥砂浆抹灰中的应用

    Polypropylene fiber applied to wall surface troweling with cement mortar

  12. 针对工程墙面存在质量病害的现象,分析了大面积水泥砂浆墙面抹灰出现裂纹、泛霜、脱落的原因,介绍了其防治措施,以保证墙面的美观效果。

    According to quality problems of wall , it analyzes causes of cracks 、 scumming and abscission in mass cement sand pulp wall plastering , and puts forward prevention measures to ensure beautiful view of wall .

  13. 论述了加气混凝土墙面易产生空裂的原因,根据工程实践经验,从材料要求、砌筑要求、墙面抹灰技术等方面,提出了相应的防治措施,以解决施工质量通病。

    The reasons caused the cracks on aerated concrete wall surface are discussed and based upon experiences in practice from material , masonry and wall plastering requirements corresponding prevention and treatment measures are proposed to eliminate this quality defect .