合金元素

hé jīn yuán sù
  • alloying element
合金元素合金元素
  1. 合金元素Cu对过热铝熔体中氢含量的影响

    Influence of the Alloying Element Cu on the Hydrogen Content in Superheated Aluminum Melt

  2. 合金元素Ti对D型石墨形成条件的影响

    Influence of alloying element titanium on formation of D-type graphite

  3. 合金元素在Mg-Li基合金中的作用

    Effect of Alloying Elements on Mg-Li Base Alloys

  4. 离子渗W,Mo手用锯条合金元素与切削性能的研究

    Alloying elements in W-Mo ionized alloy hacksaw blades and their cutting performance

  5. 合金元素P、Cu含量对铸铁短纤维结合剂组织和性能的影响

    EffEct of P and Cu Content on the Properties and Microstructure of Sintered Compacts with Short Cast Iron Fiber

  6. C元素增加钢的热导率;随温度的增加,纯铁的热导率降低,同时各合金元素对热导率的影响下降。

    With temperature increasing , the thermal conductivity of pure iron decreases and the influences of various alloying elements on thermal conductivity weaken .

  7. 探讨了SiCp/Al复合材料脉冲氩弧焊过程中合金元素Ti发生诱发反应的可行性。

    The weldability of SiCp / Al composites is investigated during pulsed TIG welding through Ti induced-reaction .

  8. 合金元素W、B对MoSi2发热体物理化学性能的影响

    Effects of B , W Elements to the Physical and Chemical Properties of MoSi_2

  9. 合金元素对TiC与钢润湿性的影响

    Effect of Alloying Elements on Wettability between steel and TiC

  10. 金属间化合物FeAl与α-Al2O3的界面润湿行为及合金元素Y和Nb的作用

    Wettability of Intermetallic Fe-40al / α - Al2O3 System and the Effect of Microalloys Y and Nb

  11. 着重分析了Mn、Ti、B合金元素对提高低温韧性的作用。

    The effect of alloying elements Mn , Ti and B on the improvement of cryogenic toughness is mainly discussed .

  12. 对于前者合金元素M指Cr,Mo,W,Zr和Co;

    Alloying element M for the former represents Cr , Mo , W , Zr and Co ;

  13. 合金元素Ni、Mo、W及熔渗铜对烧结钢耐磨性的影响

    Influence of alloy elements Ni 、 Mo 、 W and copper infiltrated on wear resistance of sintered steels

  14. 合金元素对Si3N4陶瓷生成的影响

    Effects of Alloy Elements on Silicon Nitride Ceramics Synthesis

  15. 微合金元素V抑制形变诱导铁素体相变的进行,阻碍铁素体晶粒长大,起到细化晶粒的作用。

    Vanadium restrains the deformation induced ferrite transformation but hinders the grain growth of ferrite and acts as a grain refinement .

  16. 通过少量C与适量合金元素Mn、Si、Cr配合,制备了低碳马氏体型非调质钢。

    A martensitic microalloyed steel was prepared by addition of low carbon and suitable alloying elements such as Mn , Si and Cr.

  17. 铬钢的耐海水腐蚀性不仅与Cr的含量有关,还与其他复合合金元素有关。

    Corrosion resistance of chromium steels in seawater changes not only with chromium content , but also with other alloying elements combined with Cr.

  18. 研究了不同合金元素Fe、Mo、Al及添加稀土元素Nd对粉末钛合金烧结行为及力学性能的影响,并得到了烧结性能和力学性能优良的粉末钛合金。

    Effects of Fe , Mo , Al , Nd elements on the sintering behavior and mechanical properties of titanium alloys were investigated .

  19. 合金元素Cr,Al对Sn-Ag-Cu基无铅钎料高温抗氧化和润湿性的影响

    Effect of Alloying Elements Cr , Al on High-Temperature Oxidation Resistance and Wettability of Sn-Ag-Cu Based Lead-Free Solder

  20. 研究结果表明,润滑剂能有效地降低氧气扩散速率及合金元素如Al、Fe、V的扩散速率。

    The performance of lubricant can be obviously to reduce the diffusion of oxidizing atmosphere and alloying elements , such as Al , Fe , V.

  21. 金属间化合物TiAl中的合金元素-结构缺陷复合体电子结构与材料物性

    Electronic Structure of Alloying Element-Structure Defect Complexes and Relating Material Property for Intermetallic Compound TiAl

  22. 用SEM波谱分析手段,定性研究了合金元素铌在新锆合金中的存在方式。

    The existing form of niobium in zirconium-based alloy containing Fe , Sn , Cr alloying elements was researched qualitatively by means of SEM .

  23. 研究了合金元素Cu、Mg、Zr对合金组织结构和力学性能的影响。

    The effects of alloy elements Cu , Mg , Zr on construction and properties of alloys are also studied in this paper .

  24. 利用电子显微及X射线衍射仪分析研究了C/Cu复合材料的界面特性及合金元素铁对C/Cu复合材料界面特性的影响.研究表明复合材料界面既无化学反应也无扩散发生,C/Cu界面是物理结合。

    The interface character of C / Cu composite and the influence of alloy element Fe are studied by means of electron microscopic analysis and X-ray diffractometer .

  25. 界面及两侧合金元素扩散的浓度呈梯度变化,尤其Al元素在焊缝中扩散的浓度梯度最显著。

    The concentration of alloy elements of interface and both side of interface change by grads , especially , aluminum obviously change by grads on welding seam .

  26. 合金元素对Al-Li合金时效行为和力学性能的影响

    Effect of alloying elements on the precipitation and tensile properties of Al-Li Alloys

  27. 稀土与Mg、Zn、Cu等合金元素适当组合改善润湿性的效果比单一稀土明显。

    The suitable combination of rare earths and alloying elements ( Mg , Zn , Cu ) improves wettability muchmore remarkably than a single rare earth element .

  28. 在这些阻燃方法中,添加合金元素法对镁合金阻燃具有明显作用,富Ce稀土的添加同样对镁合金的阻燃具有显著作用。

    In the methods , alloying element addition , including Ce rich RE , has the obvious effect on ignition proof of Mg alloy .

  29. 研究了不同加入量合金元素Cr;

    This paper discusses the property of corrosion resisting high temperature strength of nickel-base sigle crystal alloys with different additive amount of alloy elements such as Cr ;

  30. 合金元素Mo在一定条件下与介质作用形成Fe2(MoO4)3相。

    Experimental results show that the alloying element Mo reacted with corrosive medium to form Fe_2 ( MoO_4 ) _3 phase .